From:   Florian Eckert <fe@dev.tdt.de>
To:     u.kleine-koenig@pengutronix.de, gregkh@linuxfoundation.org,
        jirislaby@kernel.org, pavel@ucw.cz, lee@kernel.org
Cc:     linux-kernel@vger.kernel.org, linux-leds@vger.kernel.org,
        Eckert.Florian@googlemail.com
Subject: [PATCH 0/2] leds: ledtrig-tty: mode xtension
Date:   Mon, 13 Feb 2023 15:06:36 +0100
Message-ID: <20230213140638.620206-1-fe@dev.tdt.de>
MIME-Version: 1.0
Content-Transfer-Encoding: quoted-printable
Precedence: bulk

The following patch set adds the possibility to change the tty trigger
modes. Until now, the LED is flashed when data is transmitted. With a
legacy serial interface there are additional signal lines.
If this line changes then the LED is turned on/off.

CTS: Clear To Send       -> DCE is ready to accept data from the DTE
DSR: Data Set Ready      -> DCE is ready to receive and send data.
CAR: Data Carrier Detect -> DCE is receiving a carrier from a remote DCE.
RNG: Ring Indicator      -> DCE has detected an incoming ring on the line=
.

Florian Eckert (2):
  tty: new helper function tty_get_mget
  leds: trigger: ledtrig-tty: add additional modes

 .../ABI/testing/sysfs-class-led-trigger-tty   |  16 ++
 drivers/leds/trigger/ledtrig-tty.c            | 148 ++++++++++++++++--
 drivers/tty/tty_io.c                          |  32 +++-
 include/linux/tty.h                           |   3 +-
 4 files changed, 176 insertions(+), 23 deletions(-)

--=20
2.30.2