From:   Aidan MacDonald <aidanmacdonald.0x0@gmail.com>
To:     agross@kernel.org, andersson@kernel.org, lee@kernel.org
Cc:     konrad.dybcio@linaro.org, linux-arm-msm@vger.kernel.org,
        linux-kernel@vger.kernel.org
Subject: [PATCH v1 4/4] mfd: qcom-pm8008: Remove workaround for a regmap-irq quirk
Date:   Thu, 16 Feb 2023 22:22:14 +0000
Message-Id: <20230216222214.138671-5-aidanmacdonald.0x0@gmail.com>
In-Reply-To: <20230216222214.138671-1-aidanmacdonald.0x0@gmail.com>
References: <20230216222214.138671-1-aidanmacdonald.0x0@gmail.com>
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit
Precedence: bulk

Remove pm8008_init(), which according to the comments exists only
as a workaround for regmap-irq's odd treatment of type registers.
This workaround shouldn't be needed anymore because this driver
uses config registers, which are always programmed by regmap-irq
no matter what the initial register state is.

Signed-off-by: Aidan MacDonald <aidanmacdonald.0x0@gmail.com>
---
 drivers/mfd/qcom-pm8008.c | 30 ------------------------------
 1 file changed, 30 deletions(-)

diff --git a/drivers/mfd/qcom-pm8008.c b/drivers/mfd/qcom-pm8008.c
index 4bcdf0e50c40..a33fbc42ac8e 100644
--- a/drivers/mfd/qcom-pm8008.c
+++ b/drivers/mfd/qcom-pm8008.c
@@ -142,30 +142,6 @@ static struct regmap_config qcom_mfd_regmap_cfg = {
 	.max_register	= 0xFFFF,
 };
 
-static int pm8008_init(struct regmap *regmap)
-{
-	int rc;
-
-	/*
-	 * Set TEMP_ALARM peripheral's TYPE so that the regmap-irq framework
-	 * reads this as the default value instead of zero, the HW default.
-	 * This is required to enable the writing of TYPE registers in
-	 * regmap_irq_sync_unlock().
-	 */
-	rc = regmap_write(regmap, (PM8008_TEMP_ALARM_ADDR | INT_SET_TYPE_OFFSET), BIT(0));
-	if (rc)
-		return rc;
-
-	/* Do the same for GPIO1 and GPIO2 peripherals */
-	rc = regmap_write(regmap, (PM8008_GPIO1_ADDR | INT_SET_TYPE_OFFSET), BIT(0));
-	if (rc)
-		return rc;
-
-	rc = regmap_write(regmap, (PM8008_GPIO2_ADDR | INT_SET_TYPE_OFFSET), BIT(0));
-
-	return rc;
-}
-
 static int pm8008_probe_irq_peripherals(struct device *dev,
 					struct regmap *regmap,
 					int client_irq)
@@ -174,12 +150,6 @@ static int pm8008_probe_irq_peripherals(struct device *dev,
 	struct regmap_irq_type *type;
 	struct regmap_irq_chip_data *irq_data;
 
-	rc = pm8008_init(regmap);
-	if (rc) {
-		dev_err(dev, "Init failed: %d\n", rc);
-		return rc;
-	}
-
 	for (i = 0; i < ARRAY_SIZE(pm8008_irqs); i++) {
 		type = &pm8008_irqs[i].type;
 
-- 
2.39.2