From:   Philippe Schenker <dev@pschenker.ch>
To:     devicetree@vger.kernel.org, Shawn Guo <shawnguo@kernel.org>,
        Sascha Hauer <s.hauer@pengutronix.de>
Cc:     NXP Linux Team <linux-imx@nxp.com>,
        Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
        Rob Herring <robh+dt@kernel.org>,
        Pengutronix Kernel Team <kernel@pengutronix.de>,
        Frank Rowand <frowand.list@gmail.com>,
        linux-arm-kernel@lists.infradead.org,
        Fabio Estevam <festevam@gmail.com>,
        Philippe Schenker <philippe.schenker@toradex.com>,
        linux-kernel@vger.kernel.org
Subject: [PATCH v1 18/25] arm64: dts: colibri-imx8x: Add no-1-8-v to sd-card
Date:   Wed,  8 Mar 2023 13:52:52 +0100
Message-Id: <20230308125300.58244-19-dev@pschenker.ch>
In-Reply-To: <20230308125300.58244-1-dev@pschenker.ch>
References: <20230308125300.58244-1-dev@pschenker.ch>
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit
Precedence: bulk

From: Philippe Schenker <philippe.schenker@toradex.com>

Many Colibri carrier boards are using 3.3V pull-up resistors on the
SD-Card connector. Letting it switch to 1.8V is an invalid state.

Do prevent this from happening by keeping the signaling voltage at 3.3V.

Signed-off-by: Philippe Schenker <philippe.schenker@toradex.com>
---

 arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi | 1 +
 1 file changed, 1 insertion(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi b/arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi
index 180a1d940b8d..f09a6aad6275 100644
--- a/arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi
@@ -303,6 +303,7 @@ &usdhc2 {
 	bus-width = <4>;
 	cd-gpios = <&lsio_gpio3 9 GPIO_ACTIVE_LOW>;
 	disable-wp;
+	no-1-8-v;
 	vmmc-supply = <&reg_module_3v3>;
 };
 
-- 
2.39.2