Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 2620:137:e000::1:20 as permitted sender) client-ip=2620:137:e000::1:20;
From:   Adam Ford <aford173@gmail.com>
To:     dri-devel@lists.freedesktop.org
Cc:     aford@beaconembedded.com, Adam Ford <aford173@gmail.com>,
        Chen-Yu Tsai <wenst@chromium.org>,
        Frieder Schrempf <frieder.schrempf@kontron.de>,
        Michael Walle <michael@walle.cc>,
        Andrzej Hajda <andrzej.hajda@intel.com>,
        Neil Armstrong <neil.armstrong@linaro.org>,
        Robert Foss <rfoss@kernel.org>,
        Laurent Pinchart <Laurent.pinchart@ideasonboard.com>,
        Jonas Karlman <jonas@kwiboo.se>,
        Jernej Skrabec <jernej.skrabec@gmail.com>,
        David Airlie <airlied@gmail.com>,
        Daniel Vetter <daniel@ffwll.ch>,
        Inki Dae <inki.dae@samsung.com>,
        Jagan Teki <jagan@amarulasolutions.com>,
        Marek Szyprowski <m.szyprowski@samsung.com>,
        Marek Vasut <marex@denx.de>, linux-kernel@vger.kernel.org
Subject: [PATCH V5 5/6] drm: bridge: samsung-dsim: Dynamically configure DPHY timing
Date:   Sat,  6 May 2023 14:24:52 -0500
Message-Id: <20230506192453.725621-6-aford173@gmail.com>
In-Reply-To: <20230506192453.725621-1-aford173@gmail.com>
References: <20230506192453.725621-1-aford173@gmail.com>
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit
Precedence: bulk

The DPHY timings are currently hard coded. Since the input
clock can be variable, the phy timings need to be variable
too.  Add an additional variable to the driver data to enable
this feature to prevent breaking boards that don't support it.

The phy_mipi_dphy_get_default_config function configures the
DPHY timings in pico-seconds, and a small macro converts those
timings into clock cycles based on the pixel clock rate.

Signed-off-by: Adam Ford <aford173@gmail.com>
Tested-by: Chen-Yu Tsai <wenst@chromium.org>
Tested-by: Frieder Schrempf <frieder.schrempf@kontron.de>
Reviewed-by: Frieder Schrempf <frieder.schrempf@kontron.de>
Tested-by: Michael Walle <michael@walle.cc>
---
 drivers/gpu/drm/bridge/samsung-dsim.c | 74 ++++++++++++++++++++++++---
 include/drm/bridge/samsung-dsim.h     |  1 +
 2 files changed, 68 insertions(+), 7 deletions(-)

diff --git a/drivers/gpu/drm/bridge/samsung-dsim.c b/drivers/gpu/drm/bridge/samsung-dsim.c
index 08266303c261..d19a5c87b749 100644
--- a/drivers/gpu/drm/bridge/samsung-dsim.c
+++ b/drivers/gpu/drm/bridge/samsung-dsim.c
@@ -218,6 +218,8 @@
 
 #define OLD_SCLK_MIPI_CLK_NAME		"pll_clk"
 
+#define PS_TO_CYCLE(ps, hz) DIV64_U64_ROUND_CLOSEST(((ps) * (hz)), 1000000000000ULL)
+
 static const char *const clk_names[5] = {
 	"bus_clk",
 	"sclk_mipi",
@@ -487,6 +489,7 @@ static const struct samsung_dsim_driver_data imx8mm_dsi_driver_data = {
 	.m_min = 64,
 	.m_max = 1023,
 	.min_freq = 1050,
+	.dynamic_dphy = 1,
 };
 
 static const struct samsung_dsim_driver_data *
@@ -698,13 +701,50 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
 	const struct samsung_dsim_driver_data *driver_data = dsi->driver_data;
 	const unsigned int *reg_values = driver_data->reg_values;
 	u32 reg;
+	struct drm_display_mode *m = &dsi->mode;
+	int bpp = mipi_dsi_pixel_format_to_bpp(dsi->format);
+	struct phy_configure_opts_mipi_dphy cfg;
+	int clk_prepare, lpx, clk_zero, clk_post, clk_trail;
+	int hs_exit, hs_prepare, hs_zero, hs_trail;
+	unsigned long long clock_in_hz = m->clock * 1000;
 
 	if (driver_data->has_freqband)
 		return;
 
+	/* The dynamic_phy has the ability to adjust PHY Timing settings */
+	if (driver_data->dynamic_dphy) {
+		phy_mipi_dphy_get_default_config(clock_in_hz, bpp, dsi->lanes, &cfg);
+
+		/*
+		 * TODO:
+		 * The tech reference manual for i.MX8M Mini/Nano/Plus
+		 * doesn't state what the definition of the PHYTIMING
+		 * bits are beyond their address and bit position.
+		 * After reviewing NXP's downstream code, it appears
+		 * that the various PHYTIMING registers take the number
+		 * of cycles and use various dividers on them.  This
+		 * calculation does not result in an exact match to the
+		 * downstream code, but it is very close, and it appears
+		 * to sync at a variety of resolutions. If someone
+		 * can get a more accurate mathematical equation needed
+		 * for these registers, this should be updated.
+		 */
+
+		lpx = PS_TO_CYCLE(cfg.lpx, clock_in_hz);
+		hs_exit = PS_TO_CYCLE(cfg.hs_exit, clock_in_hz);
+		clk_prepare = PS_TO_CYCLE(cfg.clk_prepare, clock_in_hz);
+		clk_zero = PS_TO_CYCLE(cfg.clk_zero, clock_in_hz);
+		clk_post = PS_TO_CYCLE(cfg.clk_post, clock_in_hz);
+		clk_trail = PS_TO_CYCLE(cfg.clk_trail, clock_in_hz);
+		hs_prepare = PS_TO_CYCLE(cfg.hs_prepare, clock_in_hz);
+		hs_zero = PS_TO_CYCLE(cfg.hs_zero, clock_in_hz);
+		hs_trail = PS_TO_CYCLE(cfg.hs_trail, clock_in_hz);
+	}
+
 	/* B D-PHY: D-PHY Master & Slave Analog Block control */
 	reg = reg_values[PHYCTRL_ULPS_EXIT] | reg_values[PHYCTRL_VREG_LP] |
 		reg_values[PHYCTRL_SLEW_UP];
+
 	samsung_dsim_write(dsi, DSIM_PHYCTRL_REG, reg);
 
 	/*
@@ -712,7 +752,11 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
 	 * T HS-EXIT: Time that the transmitter drives LP-11 following a HS
 	 *	burst
 	 */
-	reg = reg_values[PHYTIMING_LPX] | reg_values[PHYTIMING_HS_EXIT];
+	if (driver_data->dynamic_dphy)
+		reg  = DSIM_PHYTIMING_LPX(lpx) | DSIM_PHYTIMING_HS_EXIT(hs_exit);
+	else
+		reg = reg_values[PHYTIMING_LPX] | reg_values[PHYTIMING_HS_EXIT];
+
 	samsung_dsim_write(dsi, DSIM_PHYTIMING_REG, reg);
 
 	/*
@@ -728,10 +772,17 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
 	 * T CLK-TRAIL: Time that the transmitter drives the HS-0 state after
 	 *	the last payload clock bit of a HS transmission burst
 	 */
-	reg = reg_values[PHYTIMING_CLK_PREPARE] |
-		reg_values[PHYTIMING_CLK_ZERO] |
-		reg_values[PHYTIMING_CLK_POST] |
-		reg_values[PHYTIMING_CLK_TRAIL];
+	if (driver_data->dynamic_dphy) {
+		reg = DSIM_PHYTIMING1_CLK_PREPARE(clk_prepare)	|
+		      DSIM_PHYTIMING1_CLK_ZERO(clk_zero)	|
+		      DSIM_PHYTIMING1_CLK_POST(clk_post)	|
+		      DSIM_PHYTIMING1_CLK_TRAIL(clk_trail);
+	} else {
+		reg = reg_values[PHYTIMING_CLK_PREPARE] |
+		      reg_values[PHYTIMING_CLK_ZERO] |
+		      reg_values[PHYTIMING_CLK_POST] |
+		      reg_values[PHYTIMING_CLK_TRAIL];
+	}
 
 	samsung_dsim_write(dsi, DSIM_PHYTIMING1_REG, reg);
 
@@ -744,8 +795,17 @@ static void samsung_dsim_set_phy_ctrl(struct samsung_dsim *dsi)
 	 * T HS-TRAIL: Time that the transmitter drives the flipped differential
 	 *	state after last payload data bit of a HS transmission burst
 	 */
-	reg = reg_values[PHYTIMING_HS_PREPARE] | reg_values[PHYTIMING_HS_ZERO] |
-		reg_values[PHYTIMING_HS_TRAIL];
+
+	if (driver_data->dynamic_dphy) {
+		reg = DSIM_PHYTIMING2_HS_PREPARE(hs_prepare) |
+		      DSIM_PHYTIMING2_HS_ZERO(hs_zero) |
+		      DSIM_PHYTIMING2_HS_TRAIL(hs_trail);
+	} else {
+		reg = reg_values[PHYTIMING_HS_PREPARE] |
+		      reg_values[PHYTIMING_HS_ZERO] |
+		      reg_values[PHYTIMING_HS_TRAIL];
+	}
+
 	samsung_dsim_write(dsi, DSIM_PHYTIMING2_REG, reg);
 }
 
diff --git a/include/drm/bridge/samsung-dsim.h b/include/drm/bridge/samsung-dsim.h
index a1a5b2b89a7a..76ea8a1720cc 100644
--- a/include/drm/bridge/samsung-dsim.h
+++ b/include/drm/bridge/samsung-dsim.h
@@ -62,6 +62,7 @@ struct samsung_dsim_driver_data {
 	const unsigned int *reg_values;
 	u16 m_min;
 	u16 m_max;
+	bool dynamic_dphy;
 };
 
 struct samsung_dsim_host_ops {
-- 
2.39.2