Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 2620:137:e000::1:20 as permitted sender) client-ip=2620:137:e000::1:20;
From:   Jerome Neanne <jneanne@baylibre.com>
Subject: [PATCH v3 0/2] Add support for TI TPS65219 PMIC GPIO interface.
Date:   Fri, 26 May 2023 17:06:02 +0200
Message-Id: <20230511-tps65219-add-gpio-support-v3-0-19837a34d820@baylibre.com>
MIME-Version: 1.0
Content-Type: text/plain; charset="utf-8"
Content-Transfer-Encoding: 7bit
To:     Linus Walleij <linus.walleij@linaro.org>,
        Bartosz Golaszewski <brgl@bgdev.pl>,
        Tony Lindgren <tony@atomide.com>, Lee Jones <lee@kernel.org>
Cc:     linux-kernel@vger.kernel.org, linux-gpio@vger.kernel.org,
        linux-omap@vger.kernel.org,
        Jonathan Cormier <jcormier@criticallink.com>,
        Jerome Neanne <jneanne@baylibre.com>
Precedence: bulk

Changes in v3:
- Linus Walleij Review:
	- put test code under IS_ENABLED(DEBUG)
- Bartosz Golaszewski Review:
	- nits: alphabetical ordering for includes, newline after
	  return, 
	- Add error message on regmap_update_bits failure.
	- Change variable name in: tps65219_template_chip so that it's
	  clear that gpio_chip get's a copy of this template structure.

- Link to v2: https://lore.kernel.org/r/20230511-tps65219-add-gpio-support-v2-0-60feb64d649a@baylibre.com

Add support for TI TPS65219 PMIC GPIO interface.

GPIO interface consist in 3 pins:
Two GPIOS are output only: GPO1, GPO2.

GPIO0 is used for multi device support:
- The input-functionality is only used in multi-PMIC configuration
- In single-PMIC, it can be used as an output

The configuration is static and flashed in NVM in factory.
Description tps65219.pdf chapter 7.3.13

Linux must not change MULTI_DEVICE_ENABLE bit at run time.

This was done for test purpose only to check input/output
correct behavior on EVM board (no access to different NVM config).

Tested on k3-am62x-lp-sk board. This board MULTI_DEVICE_ENABLE=0

Despite the register bits are out of order,
driver is remapping in natural order:
GPIO0 is gpiochip line 0
GPO1/2 are gpiochip line 1/2

Initial version by Jon Cormier on TI Mainline.
Ported upstream by Jerome Neanne

PMIC datasheet:
Link: https://www.ti.com/lit/ds/symlink/tps65219.pdf

Changes in v2:
andy.shevchenko review
- Typo and indentation in commit message.
- Clarify Co-developer role.
- Specify name for module.
- Code simplification for tps65219_gpio_set
- Put test code into #if 0 ... #endif to make it easier to re-use
- Formatting for .driver
- remove dupplicated error management => dead code

Previous version:
v1 - https://lore.kernel.org/all/20230224113837.874264-1-jneanne@baylibre.com/

Co-developed-by: Jonathan Cormier <jcormier@criticallink.com>
Signed-off-by: Jonathan Cormier <jcormier@criticallink.com>
Signed-off-by: Jerome Neanne <jneanne@baylibre.com>

Jerome Neanne (2):
  gpio: tps65219: add GPIO support for TPS65219 PMIC
  mfd: tps65219: Add gpio cell instance

 MAINTAINERS                  |   1 +
 drivers/gpio/Kconfig         |  13 +++
 drivers/gpio/Makefile        |   1 +
 drivers/gpio/gpio-tps65219.c | 167 +++++++++++++++++++++++++++++++++++
 drivers/mfd/tps65219.c       |   7 +-
 5 files changed, 188 insertions(+), 1 deletion(-)
 create mode 100644 drivers/gpio/gpio-tps65219.c

--
2.34.1

---
Jerome Neanne (2):
      gpio: tps65219: add GPIO support for TPS65219 PMIC
      mfd: tps65219: Add gpio cell instance

 MAINTAINERS                  |   1 +
 drivers/gpio/Kconfig         |  17 ++++
 drivers/gpio/Makefile        |   1 +
 drivers/gpio/gpio-tps65219.c | 183 +++++++++++++++++++++++++++++++++++++++++++
 drivers/mfd/tps65219.c       |   2 +-
 5 files changed, 203 insertions(+), 1 deletion(-)
---
base-commit: 8ded96e4d9a6da88bdbad61350cc6147b7c0c00c
change-id: 20230511-tps65219-add-gpio-support-322bdb4e0297

Best regards,
-- 
Jerome Neanne <jneanne@baylibre.com>