Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 2620:137:e000::1:20 as permitted sender) client-ip=2620:137:e000::1:20;
From:   Corentin Labbe <clabbe@baylibre.com>
To:     gregkh@linuxfoundation.org, johan@kernel.org
Cc:     linux-kernel@vger.kernel.org, linux-usb@vger.kernel.org,
        david@ixit.cz, Corentin Labbe <clabbe@baylibre.com>
Subject: [PATCH v6 0/2] usb: serial: add support for CH348
Date:   Wed, 28 Jun 2023 13:38:32 +0000
Message-Id: <20230628133834.1527941-1-clabbe@baylibre.com>
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit
Precedence: bulk

Hello

The CH348 is an octo serial to USB adapter.
The following patch adds a driver for supporting it.
Since there is no public datasheet, unfortunatly it remains some magic values.

It was tested with a large range of baud from 1200 to 1500000 and used with
success in one of our kernel CI testlab.

Regards

Changes since v1:
- use a data structure for encoding/decoding messages.
- check if needed endpoints exists
- fix URB leak in ch348_allocate_status_read error case
- test for maximum baud rate as stated by datasheet

Changes since v2:
- specify ch348_rxbuf data length
- Use correct speed_t dwDTERate instead of __le32
- test for maximum baud rate supported according to datasheet
- Use a define for CH348_TX_HDRSIZE

Changes since v3
- Fixed all reported problem from https://lore.kernel.org/lkml/Y5NDwEakGJbmB6+b@Red/T/#mb6234d0427cfdabf412190565e215995a41482dd
  Mostly reworked the endpoint mux to be the same than mx_uport

Changes since v4:
- The V4 was sent against stable and next have ch348_set_termios ktermios
  parameter const that I forgot to change

Changes since v5:
- Fixed all reported problem from https://lore.kernel.org/lkml/20230106135338.643951-1-clabbe@baylibre.com/T/#m044aab24dfb652ea34aa06f8ef704da9d6a2e036
- Major change is dropping of all status handling which was unused.
  It will be probably necessary to bring it back when using GPIO.
  This will be done when I will finish my next devboard.

Corentin Labbe (2):
  usb: serial: add support for CH348
  usb: serial: add myself as maintainer of CH348

 MAINTAINERS                 |   5 +
 drivers/usb/serial/Kconfig  |   9 +
 drivers/usb/serial/Makefile |   1 +
 drivers/usb/serial/ch348.c  | 491 ++++++++++++++++++++++++++++++++++++
 4 files changed, 506 insertions(+)
 create mode 100644 drivers/usb/serial/ch348.c

-- 
2.39.3