Received-SPF: pass (google.com: domain of linux-kernel-owner@vger.kernel.org designates 2620:137:e000::1:20 as permitted sender) client-ip=2620:137:e000::1:20;
From:   Tony Lindgren <tony@atomide.com>
To:     linux-omap@vger.kernel.org
Cc:     Dave Gerlach <d-gerlach@ti.com>, Dhruva Gole <d-gole@ti.com>,
        Faiz Abbas <faiz_abbas@ti.com>,
        Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
        Keerthy <j-keerthy@ti.com>, Kevin Hilman <khilman@baylibre.com>,
        Nishanth Menon <nm@ti.com>, linux-kernel@vger.kernel.org,
        linux-arm-kernel@lists.infradead.org
Subject: [PATCH v2 3/3] bus: ti-sysc: Configure uart quirks for k3 SoC
Date:   Wed,  9 Aug 2023 12:27:22 +0300
Message-ID: <20230809092722.11000-3-tony@atomide.com>
In-Reply-To: <20230809092722.11000-1-tony@atomide.com>
References: <20230809092722.11000-1-tony@atomide.com>
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit
Precedence: bulk

Enable the uart quirks similar to the earlier SoCs. Let's assume we are
likely going to need a k3 specific quirk mask separate from the earlier
SoCs, so let's not start changing the revision register mask at this point.

Note that SYSC_QUIRK_LEGACY_IDLE will be needed until we can remove the
need for pm_runtime_irq_safe() from 8250_omap driver.

Signed-off-by: Tony Lindgren <tony@atomide.com>
---
 drivers/bus/ti-sysc.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/bus/ti-sysc.c b/drivers/bus/ti-sysc.c
--- a/drivers/bus/ti-sysc.c
+++ b/drivers/bus/ti-sysc.c
@@ -1525,6 +1525,8 @@ static const struct sysc_revision_quirk sysc_revision_quirks[] = {
 		   SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
 	SYSC_QUIRK("uart", 0, 0x50, 0x54, 0x58, 0x47422e03, 0xffffffff,
 		   SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
+	SYSC_QUIRK("uart", 0, 0x50, 0x54, 0x58, 0x47424e03, 0xffffffff,
+		   SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
 
 	/* Quirks that need to be set based on the module address */
 	SYSC_QUIRK("mcpdm", 0x40132000, 0, 0x10, -ENODEV, 0x50000800, 0xffffffff,
-- 
2.41.0