Received-SPF: pass (google.com: domain of linux-kernel+bounces-199385-linux.lists.archive=gmail.com@vger.kernel.org designates 147.75.48.161 as permitted sender) client-ip=147.75.48.161;
Date: Mon, 3 Jun 2024 16:47:28 +0100
From: "Russell King (Oracle)" <linux@armlinux.org.uk>
To: Daniel Golle <daniel@makrotopia.org>
Cc: Sky Huang <SkyLake.Huang@mediatek.com>, Andrew Lunn <andrew@lunn.ch>,
	Heiner Kallweit <hkallweit1@gmail.com>,
	"David S. Miller" <davem@davemloft.net>,
	Eric Dumazet <edumazet@google.com>,
	Jakub Kicinski <kuba@kernel.org>, Paolo Abeni <pabeni@redhat.com>,
	Qingfang Deng <dqfext@gmail.com>,
	Matthias Brugger <matthias.bgg@gmail.com>,
	AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>,
	linux-kernel@vger.kernel.org, netdev@vger.kernel.org,
	linux-arm-kernel@lists.infradead.org,
	linux-mediatek@lists.infradead.org,
	Steven Liu <Steven.Liu@mediatek.com>
Subject: Re: [PATCH net-next v6 5/5] net: phy: add driver for built-in 2.5G
 ethernet PHY on MT7988
Message-ID: <Zl3lkIDqnt4JD//u@shell.armlinux.org.uk>
References: <20240603121834.27433-1-SkyLake.Huang@mediatek.com>
 <20240603121834.27433-6-SkyLake.Huang@mediatek.com>
 <Zl3ELbG8c8y0/4DN@shell.armlinux.org.uk>
 <Zl3Fwoiv1bJlGaQZ@makrotopia.org>
 <Zl3IGN5ZHCQfQfmt@shell.armlinux.org.uk>
 <Zl3Yo3dwQlXEfP3i@makrotopia.org>
Precedence: bulk
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
In-Reply-To: <Zl3Yo3dwQlXEfP3i@makrotopia.org>
Sender: Russell King (Oracle) <linux@armlinux.org.uk>

On Mon, Jun 03, 2024 at 03:52:19PM +0100, Daniel Golle wrote:
> On Mon, Jun 03, 2024 at 02:41:44PM +0100, Russell King (Oracle) wrote:
> > On Mon, Jun 03, 2024 at 02:31:46PM +0100, Daniel Golle wrote:
> > > On Mon, Jun 03, 2024 at 02:25:01PM +0100, Russell King (Oracle) wrote:
> > > > On Mon, Jun 03, 2024 at 08:18:34PM +0800, Sky Huang wrote:
> > > > > Add support for internal 2.5Gphy on MT7988. This driver will load
> > > > > necessary firmware, add appropriate time delay and figure out LED.
> > > > > Also, certain control registers will be set to fix link-up issues.
> > > > 
> > > > Based on our previous discussion, it may be worth checking in the
> > > > .config_init() method whether phydev->interface is one of the
> > > > PHY interface modes that this PHY supports. As I understand from one
> > > > of your previous emails, the possibilities are XGMII, USXGMII or
> > > > INTERNAL. Thus:
> > > > 
> > > > > +static int mt798x_2p5ge_phy_config_init(struct phy_device *phydev)
> > > > > +{
> > > > > +	struct pinctrl *pinctrl;
> > > > > +	int ret;
> > > > 
> > > > 	/* Check that the PHY interface type is compatible */
> > > > 	if (phydev->interface != PHY_INTERFACE_MODE_INTERNAL &&
> > > > 	    phydev->interface != PHY_INTERFACE_MODE_XGMII &&
> > > > 	    phydev->interface != PHY_INTERFACE_MODE_USXGMII)
> > > > 		return -ENODEV;
> > > 
> > > The PHY is built-into the SoC, and as such the connection type should
> > > always be "internal". The PHY does not exist as dedicated IC, only
> > > as built-in part of the MT7988 SoC.
> > 
> > That's not how it was described to me by Sky.
> > 
> > If what you say is correct, then the implementation of
> > mt798x_2p5ge_phy_get_rate_matching() which checks for interface modes
> > other than INTERNAL is not correct. Also it means that config_init()
> > should not permit anything but INTERNAL.
> 
> The way the PHY is connected to the MAC *inside the chip* is XGMII
> according the MediaTek. So call it "internal" or "xgmii", however, up to
> my knowledge it's a fact that there is **only one way** this PHY is
> connected and used, and that is being an internal part of the MT7988 SoC.
> 
> Imho, as there are no actual XGMII signals exposed anywhere I'd use
> "internal" to describe the link between MAC and PHY (which are both
> inside the same chip package).

I don't care what gets decided about what's acceptable for the PHY to
accept, just that it checks for the acceptable modes in .config_init()
and the .get_rate_matching() method is not checking for interface
modes that are not permitted.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!