Received-SPF: pass (google.com: domain of linux-kernel+bounces-200480-linux.lists.archive=gmail.com@vger.kernel.org designates 147.75.48.161 as permitted sender) client-ip=147.75.48.161;
From: Usama Arif <usamaarif642@gmail.com>
To: akpm@linux-foundation.org
Cc: hannes@cmpxchg.org,
	willy@infradead.org,
	yosryahmed@google.com,
	nphamcs@gmail.com,
	chengming.zhou@linux.dev,
	linux-mm@kvack.org,
	linux-kernel@vger.kernel.org,
	kernel-team@meta.com,
	Usama Arif <usamaarif642@gmail.com>
Subject: [PATCH v2 0/2] mm: clear pte for folios that are zero filled
Date: Tue,  4 Jun 2024 11:58:23 +0100
Message-ID: <20240604105950.1134192-1-usamaarif642@gmail.com>
Precedence: bulk
MIME-Version: 1.0
Content-Transfer-Encoding: 8bit

As shown in the patchseries that introduced the zswap same-filled
optimization [1], 10-20% of the pages stored in zswap are same-filled.
This is also observed across Meta's server fleet.
By using VM counters in swap_writepage (not included in this
patchseries) it was found that less than 1% of the same-filled
pages to be swapped out are non-zero pages.

For conventional swap setup (without zswap), rather than reading/writing
these pages to flash resulting in increased I/O and flash wear, the pte
can be cleared for those addresses at unmap time while shrinking folio
list. When this causes a page fault, do_pte_missing will take care of this
page.

When using zswap, this also means that a zswap_entry does not
need to be allocated for zero filled pages resulting in memory savings.

A similar attempt was made earlier in [2] where zswap would only track
zero-filled pages instead of same-filled.
This patchseries adds zero-filled pages optimization by default
(hence it can be used even if zswap is disabled) and removes the
same-filled code from zswap (as only 1% of the same-filled pages are
non-zero), simplifying code.

This patchseries is based on mm-unstable.

[1] https://lore.kernel.org/all/20171018104832epcms5p1b2232e2236258de3d03d1344dde9fce0@epcms5p1/
[2] https://lore.kernel.org/lkml/20240325235018.2028408-1-yosryahmed@google.com/

---
v1 -> v2:
- instead of using a bitmap in swap, clear pte for zero pages and let
  do_pte_missing handle this page at page fault. (Yosry and Matthew)
- Check end of page first when checking if folio is zero filled as
  it could lead to better performance. (Yosry)

Usama Arif (2):
  mm: clear pte for folios that are zero filled
  mm: remove code to handle same filled pages

 include/linux/rmap.h |   1 +
 mm/rmap.c            | 163 ++++++++++++++++++++++---------------------
 mm/vmscan.c          |  89 ++++++++++++++++-------
 mm/zswap.c           |  86 +++--------------------
 4 files changed, 158 insertions(+), 181 deletions(-)

-- 
2.43.0