Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S935409AbZJOTtM (ORCPT ); Thu, 15 Oct 2009 15:49:12 -0400 Received: (majordomo@vger.kernel.org) by vger.kernel.org id S935384AbZJOTtL (ORCPT ); Thu, 15 Oct 2009 15:49:11 -0400 Received: from 139.254.232.72.static.reverse.ltdomains.com ([72.232.254.139]:53050 "EHLO liberdade.minaslivre.org" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S935372AbZJOTtK (ORCPT ); Thu, 15 Oct 2009 15:49:10 -0400 From: Thadeu Lima de Souza Cascardo To: trivial@kernel.org Cc: linville@tuxdriver.com, IvDoorn@gmail.com, johannes@sipsolutions.net, users@host1.serialmonkey.com, linux-kernel@vger.kernel.org, linux-wireless@vger.kernel.org, netdev@vger.kernel.org, Thadeu Lima de Souza Cascardo Subject: [PATCH 4/8] trivial: fix some typos and punctuation in comments Date: Thu, 15 Oct 2009 16:48:23 -0300 Message-Id: <1255636103-5817-1-git-send-email-cascardo@holoscopio.com> X-Mailer: git-send-email 1.6.3.3 Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 6417 Lines: 145 Signed-off-by: Thadeu Lima de Souza Cascardo --- drivers/net/wireless/rt2x00/rt61pci.c | 36 ++++++++++++++++---------------- 1 files changed, 18 insertions(+), 18 deletions(-) diff --git a/drivers/net/wireless/rt2x00/rt61pci.c b/drivers/net/wireless/rt2x00/rt61pci.c index b20e3ea..343e565 100644 --- a/drivers/net/wireless/rt2x00/rt61pci.c +++ b/drivers/net/wireless/rt2x00/rt61pci.c @@ -51,7 +51,7 @@ MODULE_PARM_DESC(nohwcrypt, "Disable hardware encryption."); * These indirect registers work with busy bits, * and we will try maximal REGISTER_BUSY_COUNT times to access * the register while taking a REGISTER_BUSY_DELAY us delay - * between each attampt. When the busy bit is still set at that time, + * between each attempt. When the busy bit is still set at that time, * the access attempt is considered to have failed, * and we will print an error. */ @@ -386,7 +386,7 @@ static int rt61pci_config_shared_key(struct rt2x00_dev *rt2x00dev, * The driver does not support the IV/EIV generation * in hardware. However it doesn't support the IV/EIV * inside the ieee80211 frame either, but requires it - * to be provided seperately for the descriptor. + * to be provided separately for the descriptor. * rt2x00lib will cut the IV/EIV data out of all frames * given to us by mac80211, but we must tell mac80211 * to generate the IV/EIV data. @@ -397,7 +397,7 @@ static int rt61pci_config_shared_key(struct rt2x00_dev *rt2x00dev, /* * SEC_CSR0 contains only single-bit fields to indicate * a particular key is valid. Because using the FIELD32() - * defines directly will cause a lot of overhead we use + * defines directly will cause a lot of overhead, we use * a calculation to determine the correct bit directly. */ mask = 1 << key->hw_key_idx; @@ -425,11 +425,11 @@ static int rt61pci_config_pairwise_key(struct rt2x00_dev *rt2x00dev, /* * rt2x00lib can't determine the correct free * key_idx for pairwise keys. We have 2 registers - * with key valid bits. The goal is simple, read - * the first register, if that is full move to + * with key valid bits. The goal is simple: read + * the first register. If that is full, move to * the next register. - * When both registers are full, we drop the key, - * otherwise we use the first invalid entry. + * When both registers are full, we drop the key. + * Otherwise, we use the first invalid entry. */ rt2x00pci_register_read(rt2x00dev, SEC_CSR2, ®); if (reg && reg == ~0) { @@ -464,8 +464,8 @@ static int rt61pci_config_pairwise_key(struct rt2x00_dev *rt2x00dev, &addr_entry, sizeof(addr_entry)); /* - * Enable pairwise lookup table for given BSS idx, - * without this received frames will not be decrypted + * Enable pairwise lookup table for given BSS idx. + * Without this, received frames will not be decrypted * by the hardware. */ rt2x00pci_register_read(rt2x00dev, SEC_CSR4, ®); @@ -487,7 +487,7 @@ static int rt61pci_config_pairwise_key(struct rt2x00_dev *rt2x00dev, /* * SEC_CSR2 and SEC_CSR3 contain only single-bit fields to indicate * a particular key is valid. Because using the FIELD32() - * defines directly will cause a lot of overhead we use + * defines directly will cause a lot of overhead, we use * a calculation to determine the correct bit directly. */ if (key->hw_key_idx < 32) { @@ -556,7 +556,7 @@ static void rt61pci_config_intf(struct rt2x00_dev *rt2x00dev, if (flags & CONFIG_UPDATE_TYPE) { /* * Clear current synchronisation setup. - * For the Beacon base registers we only need to clear + * For the Beacon base registers, we only need to clear * the first byte since that byte contains the VALID and OWNER * bits which (when set to 0) will invalidate the entire beacon. */ @@ -1168,8 +1168,8 @@ static int rt61pci_check_firmware(struct rt2x00_dev *rt2x00dev, return FW_BAD_LENGTH; /* - * The last 2 bytes in the firmware array are the crc checksum itself, - * this means that we should never pass those 2 bytes to the crc + * The last 2 bytes in the firmware array are the crc checksum itself. + * This means that we should never pass those 2 bytes to the crc * algorithm. */ fw_crc = (data[len - 2] << 8 | data[len - 1]); @@ -1986,7 +1986,7 @@ static void rt61pci_fill_rxdone(struct queue_entry *entry, /* * Hardware has stripped IV/EIV data from 802.11 frame during - * decryption. It has provided the data seperately but rt2x00lib + * decryption. It has provided the data separately but rt2x00lib * should decide if it should be reinserted. */ rxdesc->flags |= RX_FLAG_IV_STRIPPED; @@ -2042,7 +2042,7 @@ static void rt61pci_txdone(struct rt2x00_dev *rt2x00dev) * During each loop we will compare the freshly read * STA_CSR4 register value with the value read from * the previous loop. If the 2 values are equal then - * we should stop processing because the chance it + * we should stop processing because the chance is * quite big that the device has been unplugged and * we risk going into an endless loop. */ @@ -2330,7 +2330,7 @@ static int rt61pci_init_eeprom(struct rt2x00_dev *rt2x00dev) __set_bit(CONFIG_FRAME_TYPE, &rt2x00dev->flags); /* - * Detect if this device has an hardware controlled radio. + * Detect if this device has a hardware controlled radio. */ if (rt2x00_get_field16(eeprom, EEPROM_ANTENNA_HARDWARE_RADIO)) __set_bit(CONFIG_SUPPORT_HW_BUTTON, &rt2x00dev->flags); @@ -2355,7 +2355,7 @@ static int rt61pci_init_eeprom(struct rt2x00_dev *rt2x00dev) __set_bit(CONFIG_EXTERNAL_LNA_BG, &rt2x00dev->flags); /* - * When working with a RF2529 chip without double antenna + * When working with a RF2529 chip without double antenna, * the antenna settings should be gathered from the NIC * eeprom word. */ @@ -2668,7 +2668,7 @@ static int rt61pci_conf_tx(struct ieee80211_hw *hw, u16 queue_idx, /* * We only need to perform additional register initialization - * for WMM queues/ + * for WMM queues. */ if (queue_idx >= 4) return 0; -- 1.6.3.3 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/