Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1756119Ab0FAWcB (ORCPT ); Tue, 1 Jun 2010 18:32:01 -0400 Received: from 74-93-104-97-Washington.hfc.comcastbusiness.net ([74.93.104.97]:52124 "EHLO sunset.davemloft.net" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1754260Ab0FAWb7 (ORCPT ); Tue, 1 Jun 2010 18:31:59 -0400 Date: Tue, 01 Jun 2010 15:32:09 -0700 (PDT) Message-Id: <20100601.153209.135521213.davem@davemloft.net> To: mikpe@it.uu.se Cc: netdev@vger.kernel.org, mcarlson@broadcom.com, linux-kernel@vger.kernel.org, sparclinux@vger.kernel.org Subject: Re: [2.6.35-rc1 regression] tg3 vpd r/w failed From: David Miller In-Reply-To: <19461.26529.591960.912204@pilspetsen.it.uu.se> References: <19461.26529.591960.912204@pilspetsen.it.uu.se> X-Mailer: Mew version 6.3 on Emacs 23.1 / Mule 6.0 (HANACHIRUSATO) Mime-Version: 1.0 Content-Type: Text/Plain; charset=us-ascii Content-Transfer-Encoding: 7bit Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 1607 Lines: 34 Mikael I'm getting tired of continuing to add the proper mailing list CC: for your sparc bug reports. Please make sure to add sparclinux@vger.kernel.org to your reports in the future. Thanks. > Booting 2.6.35-rc1 on a Sun Blade 2500 Red with builtin tg3 I get: > > tg3.c:v3.110 (April 9, 2010) > PCI: Enabling device: (0000:00:03.0), cmd 2 > ... > tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update. > tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update. > tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update. > tg3 0000:00:03.0: eth0: Tigon3 [partno(none) rev 1002] (PCI:66MHz:64-bit) MAC address ... > tg3 0000:00:03.0: eth0: attached PHY is 5703 (10/100/1000Base-T Ethernet) (WireSpeed[1]) > tg3 0000:00:03.0: eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1] > tg3 0000:00:03.0: eth0: dma_rwctrl[763f0000] dma_mask[32-bit] > ... > tg3 0000:00:03.0: eth0: No firmware running > tg3 0000:00:03.0: eth0: Link is up at 100 Mbps, full duplex > tg3 0000:00:03.0: eth0: Flow control is on for TX and on for RX > > The three 'vpd r/w failed' messages are new and did not occur with 2.6.34 > or earlier kernels. > > /Mikael -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/