Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1753532Ab1FCQoL (ORCPT ); Fri, 3 Jun 2011 12:44:11 -0400 Received: from mail-pv0-f174.google.com ([74.125.83.174]:62090 "EHLO mail-pv0-f174.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1753367Ab1FCQoJ convert rfc822-to-8bit (ORCPT ); Fri, 3 Jun 2011 12:44:09 -0400 MIME-Version: 1.0 In-Reply-To: <1306776478.2882.47.camel@ptyser-laptop> References: <1299022100-14564-4-git-send-email-ptyser@xes-inc.com> <1303317354-18188-1-git-send-email-ptyser@xes-inc.com> <20110527064238.GA31271@ponder.secretlab.ca> <20110527110130.4b3448f2@endymion.delvare> <1306506402.22090.14872.camel@petert> <20110527205526.GJ6645@ponder.secretlab.ca> <1306531794.10752.19.camel@ptyser-laptop> <1306776478.2882.47.camel@ptyser-laptop> From: Grant Likely Date: Fri, 3 Jun 2011 10:43:49 -0600 X-Google-Sender-Auth: hOgTDsf56NYQ6PFDEiica0mc1zY Message-ID: Subject: Re: [PATCH v6] gpio: Add support for Intel ICHx/3100/Series[56] GPIO To: Peter Tyser , Jean Delvare Cc: linux-kernel@vger.kernel.org, Alek Du , Samuel Ortiz , Eric Miao , =?ISO-8859-1?Q?Uwe_Kleine=2DK=F6nig?= , Mark Brown , Joe Perches , Alan Cox , Syed S Azam , Vincent Palatin Content-Type: text/plain; charset=ISO-8859-1 Content-Transfer-Encoding: 8BIT Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 7348 Lines: 142 On Mon, May 30, 2011 at 11:27 AM, Peter Tyser wrote: > On Fri, 2011-05-27 at 17:54 -0600, Grant Likely wrote: >> On Fri, May 27, 2011 at 3:29 PM, Peter Tyser wrote: >> >> > My own (completely biased) preference would be to use my driver as a >> >> > starting point, primarily because it supports newer chips that require >> >> > different access methods, as well as the older-style chips Jean's >> >> > supports. ?Its also been hanging out for about 6 months without many >> >> > complaints, a tested-by, etc. >> >> >> >> I like the /structure/ of Jean's driver better, particularly that it doesn't >> >> play games with the device model by registering devices at module load >> >> time. >> > >> > But the driver shouldn't be a PCI driver - that's worse in my opinion >> > than a platform driver. ?Multiple drivers currently use the same PCI >> > device ID as Jean's - they can't all claim the PCI device, so why should >> > Jean's GPIO driver? ?It seems incorrect, and likely to break things in >> > the future. ?Mine has its warts too, but it doesn't have the possibility >> > of negatively affect other drivers at least, as well as supports more >> > hardware. >> >> Does it conflict with other drivers in the kernel right now? ?If so, >> then I'll drop it. > > It'd take some searching of where all the PCI vendor IDs in the new > patch are used. ?I did a quick search of ICH7 and ESB2 IDs, and it > looked like: > Conflict: > - drivers/leds/leds-ss4200.c (also uses a PCI driver, also uses the GPIO > functionality of the chip) > > Uses the same device, but no conflict: > - drivers/char/sonypi.c (uses platform driver) > - drivers/watchdog/iTCO_wdt.c (uses platform driver) > - drivers/mtd/maps/esb2rom.c (has PCI driver support commented out) > > The same search would have to be performed for the other IDs to > determine if there are conflicts. ?So there is one conflict, but its > probably not a huge deal because someone using leds-ss4200.c likely > wouldn't be using the ich GPIO driver as well. ?leds-ss4200.c should > probably be converted to use the standard GPIO driver in the future. > > However, if the above non-conflicting drivers did use the same PCI > driver model as the accepted GPIO patch, there would be conflicts - > that's what I don't care for. ?The drivers above are considerate of the > fact that the device being used is a MFD while the Jean's driver is not. > > I followed the iTCO_wdt.c and sonypi.c models for my driver in an > attempt to play nice with other drivers that might require the same PCI > device. > >> Also, you're directly describing the use case for an MFD type device. >> I certainly expect either this driver or Jean's driver to be reworked >> into an MFD style device in the next cycle. > > I was following the very "popular" iTCO_wdt.c driver model. ?I'd hope > the current driver could be merged as it follows the current ICHx usage > pattern, and then they (and possibly other drivers) could all be > reworked at the same time into an MFD style driver. > >> >> If one device performs more than one function, then it should >> >> register all the interfaces from a single probe, or go in the >> >> direction of MFD devices and register a bunch of child >> >> platform_devices. >> > >> > In this case its not really "one device performing more than one >> > function", its one device specifying the location of other devices. ?The >> > device being claimed is used for FWH and IRQ configuration and happens >> > to have a pointer to a GPIO device (among other things). ?Claiming it >> > for a GPIO device seems very wrong - it has very little to do with GPIO >> > at all. >> >> Are you sure? ?My reading of the ICH10 manual is that the GPIO >> controller is very much behind the LPC bridge, and that it is entirely >> appropriate for the GPIO controller device to be registered by the PCI >> driver as a child of the PCI device, or to be registered directly by >> the PCI driver. > > I was a bit overzealous in my comment - you are correct that the GPIO > controller is behind the LPC bridge. ?However, there is a lot of other > stuff in the same device, from the Intel series 5 datasheet : "The LPC > bridge function of the PCH resides in PCI Device 31:Function 0. This > function contains many other functional units, such as DMA and Interrupt > controllers, Timers, Power Management, System Management, GPIO, RTC, and > LPC Configuration Registers." > > Thus I still don't think its correct to claim the device as only a GPIO > device - its much more, as can be seen by the current drivers which use > the same device. ?I'm having a tough time seeing how an monopolistic PCI > driver is considered better than a platform driver that follows the > structure of other drivers in use. > >> > >> >> I'm going to merge Jean's driver and leave this one out for now >> >> (sorry), but I reserve the right to replace Jean's with your driver in >> >> the next merge window. ?This is pretty much an arbitrary decision, but >> >> I may as well merge at least one of them now instead of kicking both >> >> out for another cycle. ?It really seams to me like there is still >> >> a few architectural issues to sort out in both drivers and to make >> >> sure that one driver will be useful for both of you. >> > >> > I disagree with the logic, and its a bit frustrating to have a patch >> > hanging out for 6 months to be superseded by a more recent change that >> > seems to be more likely to cause conflicts. >> >> Think about it this way; your patch wasn't going to go in this cycle >> anyway due to the current concerns I have about structure, > > I attempted to follow the driver model of the existing iTCO_wdt.c file, > which at a minimum will not negatively affect other drivers unlike the > potential of the accepted driver. ?Any comments about the platform > driver GPIO approach can also be made to the iTCO_wdt.c driver, as well > as the sonypi.c driver. Correct, those drivers are using a bad model and should also be fixed. > ?Since cleanup needs to be done anyway on those > drivers, my hope would be that the platform GPIO driver would be > accepted since it follows the status quo, and then cleanup on them all > would occur. Ah, but those drivers are already merged, whereas this new driver is not. It is perfectly reasonable for me to require that new drivers follow good practices before getting merged. I'm not even asking you to do something hard. Instead of registering both the device and the driver in the same code, I'm asking you to create a new pci_driver in drivers/mfd that registers the a child platform_device for each embedded device, including the GPIO controller. Take a look at drivers/mfd/timberdate.c as an example (although much more complicated than you need, your version will probably be somewhere around 50-100 lines of code top to bottom including comments). BTW, I also held off on asking Linus to merge Jean's version because of the possibility of conflict (Sorry Jean). After the concern was raised, I just didn't feel confident enough to push it on to Linus. g. -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/