Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1756634Ab2BHRsi (ORCPT ); Wed, 8 Feb 2012 12:48:38 -0500 Received: from xes-mad.com ([216.165.139.218]:37376 "EHLO xes-mad.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752183Ab2BHRsg (ORCPT ); Wed, 8 Feb 2012 12:48:36 -0500 Date: Wed, 08 Feb 2012 11:48:21 -0600 (CST) From: Aaron Sierra To: guenter roeck Cc: Jean Delvare , Grant Likely , LKML , Peter Tyser Subject: Re: [PATCH 3/3 v2] watchdog: Convert iTCO_wdt driver to mfd model Message-ID: In-Reply-To: <1328648878.2261.308.camel@groeck-laptop> Content-Type: text/plain; charset=ISO-8859-1 Content-Transfer-Encoding: 7bit MIME-Version: 1.0 X-Originating-IP: [10.52.0.65] X-Mailer: Zimbra 7.1.3_GA_3346 (ZimbraWebClient - GC15 (Linux)/7.1.3_GA_3346) Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Content-Length: 9907 Lines: 253 > > @@ -429,11 +463,52 @@ static int __devinit lpc_ich_probe(struct > > pci_dev *dev, > > acpi_conflict++; > > } > > > > + wdt_io_res(ICH_RES_IO_TCO)->start = base_addr + > > ACPIBASE_TCO_OFF; > > + wdt_io_res(ICH_RES_IO_TCO)->end = base_addr + > > ACPIBASE_TCO_END; > > + ret = > > acpi_check_resource_conflict(wdt_io_res(ICH_RES_IO_TCO)); > > + if (ret) { > > + acpi_conflict++; > > + goto pm_done; > > + } > > + > > + wdt_io_res(ICH_RES_IO_SMI)->start = base_addr + > > ACPIBASE_SMI_OFF; > > + wdt_io_res(ICH_RES_IO_SMI)->end = base_addr + > > ACPIBASE_SMI_END; > > + ret = > > acpi_check_resource_conflict(wdt_io_res(ICH_RES_IO_SMI)); > > + if (ret) { > > + acpi_conflict++; > > + goto pm_done; > > + } > > + > I'll have to look into the merged code, but doesn't this mean that > iTCO resource requirement conflicts impact GPIO resource > requirements ? If yes, is it possible to keep those separate ? I believe that I accounted for this properly. I attempt to assign the GPE0 resource before the iTCO resources. That way an ACPI conflict with the iTCO resources can't cause the GPE0 resource to not be assigned. > > +static int __devinit iTCO_wdt_probe(struct platform_device *dev) > > { > > int ret; > > - u32 base_address; > > - unsigned long RCBA; > > unsigned long val32; > > + struct lpc_ich_info *ich_info = dev->dev.platform_data; > > > > - /* > > - * Find the ACPI/PM base I/O address which is the base > > - * for the TCO registers (TCOBASE=ACPIBASE + 0x60) > > - * ACPIBASE is bits [15:7] from 0x40-0x43 > > - */ > > - pci_read_config_dword(pdev, 0x40, &base_address); > > - base_address &= 0x0000ff80; > > - if (base_address == 0x00000000) { > > - /* Something's wrong here, ACPIBASE has to be set > > */ > > - printk(KERN_ERR PFX "failed to get TCOBASE address, > > " > > - "device disabled by > > hardware/BIOS\n"); > > + if (!ich_info) > > + return -ENODEV; > > + > > + spin_lock_init(&iTCO_wdt_private.io_lock); > > + > > + iTCO_wdt_private.tco_res = > > + platform_get_resource(dev, IORESOURCE_IO, > > ICH_RES_IO_TCO); > > + > > + iTCO_wdt_private.smi_res = > > + platform_get_resource(dev, IORESOURCE_IO, > > ICH_RES_IO_SMI); > > + > > + iTCO_wdt_private.gcs_res = > > + platform_get_resource(dev, IORESOURCE_MEM, > > ICH_RES_MEM_GCS); > > + > > + if (!iTCO_wdt_private.tco_res || !iTCO_wdt_private.smi_res > > || > > + !iTCO_wdt_private.gcs_res) { > > + pr_info("No device detected.\n"); > > return -ENODEV; This test and return doesn't account for any of the resources that may have been successfully obtained. > > } > > - iTCO_wdt_private.iTCO_version = > > - > > iTCO_chipset_info[ent->driver_data].iTCO_version; > > - iTCO_wdt_private.ACPIBASE = base_address; > > - iTCO_wdt_private.pdev = pdev; > > - > > - /* Get the Memory-Mapped GCS register, we need it for the > > - NO_REBOOT flag (TCO v2). To get access to it you have to > > - read RCBA from PCI Config space 0xf0 and use it as base. > > - GCS = RCBA + ICH6_GCS(0x3410). */ > > + > > + iTCO_wdt_private.iTCO_version = ich_info->iTCO_version; > > + iTCO_wdt_private.dev = dev; > > + iTCO_wdt_private.pdev = to_pci_dev(dev->dev.parent); > > + > > + /* > > + * Get the Memory-Mapped GCS register, we need it for the > > + * NO_REBOOT flag (TCO v2). > > + */ > > if (iTCO_wdt_private.iTCO_version == 2) { > > - pci_read_config_dword(pdev, 0xf0, &base_address); > > - if ((base_address & 1) == 0) { > > - printk(KERN_ERR PFX "RCBA is disabled by > > hardware" > > - "/BIOS, device > > disabled\n"); > > - ret = -ENODEV; > > + if > > (!request_mem_region(iTCO_wdt_private.gcs_res->start, > > + resource_size(iTCO_wdt_private.gcs_res), > > dev->name)) { > > + ret = -EBUSY; > > goto out; > > } > > - RCBA = base_address & 0xffffc000; > > - iTCO_wdt_private.gcs = ioremap((RCBA + 0x3410), 4); > > + iTCO_wdt_private.gcs = > > ioremap(iTCO_wdt_private.gcs_res->start, > > + resource_size(iTCO_wdt_private.gcs_res)); > > } > > > > /* Check chipset's NO_REBOOT bit */ > > if (iTCO_wdt_unset_NO_REBOOT_bit() && > > iTCO_vendor_check_noreboot_on()) { > > - printk(KERN_INFO PFX "unable to reset NO_REBOOT > > flag, " > > + pr_info("unable to reset NO_REBOOT flag, " > > "device disabled by > > hardware/BIOS\n"); > > ret = -ENODEV; /* Cannot reset NO_REBOOT bit */ > > goto out_unmap; > > @@ -841,11 +559,11 @@ static int __devinit iTCO_wdt_init(struct > > pci_dev *pdev, > > iTCO_wdt_set_NO_REBOOT_bit(); > > > > /* The TCO logic uses the TCO_EN bit in the SMI_EN register > > */ > > - if (!request_region(SMI_EN, 4, "iTCO_wdt")) { > > - printk(KERN_ERR PFX > > - "I/O address 0x%04lx already in use, " > > + if (!request_region(iTCO_wdt_private.smi_res->start, > > + resource_size(iTCO_wdt_private.smi_res), > > dev->name)) { > > + pr_err("I/O address 0x%04llx already in use, " > > "device > > disabled\n", > > SMI_EN); > > - ret = -EIO; > > + ret = -EBUSY; > > goto out_unmap; > > } > > if (turn_SMI_watchdog_clear_off >= > > iTCO_wdt_private.iTCO_version) { > > @@ -855,20 +573,16 @@ static int __devinit iTCO_wdt_init(struct > > pci_dev *pdev, > > outl(val32, SMI_EN); > > } > > > > - /* The TCO I/O registers reside in a 32-byte range pointed > > to > > - by the TCOBASE value */ > > - if (!request_region(TCOBASE, 0x20, "iTCO_wdt")) { > > - printk(KERN_ERR PFX "I/O address 0x%04lx already in > > use " > > - "device > > disabled\n", TCOBASE); > > - ret = -EIO; > > + if (!request_region(iTCO_wdt_private.tco_res->start, > > + resource_size(iTCO_wdt_private.tco_res), > > dev->name)) { > > + pr_err("I/O address 0x%04llx already in use device > > disabled\n", > > + TCOBASE); > > + ret = -EBUSY; > > goto unreg_smi_en; > > } > > > > - printk(KERN_INFO PFX > > - "Found a %s TCO device (Version=%d, > > TCOBASE=0x%04lx)\n", > > - iTCO_chipset_info[ent->driver_data].name, > > - > > iTCO_chipset_info[ent->driver_data].iTCO_version, > > - TCOBASE); > > + pr_info("Found a %s TCO device (Version=%d, > > TCOBASE=0x%04llx)\n", > > + ich_info->name, ich_info->iTCO_version, TCOBASE); > > > > /* Clear out the (probably old) status */ > > outw(0x0008, TCO1_STS); /* Clear the Time Out Status bit */ > > @@ -882,79 +596,38 @@ static int __devinit iTCO_wdt_init(struct > > pci_dev *pdev, > > if not reset to the default */ > > if (iTCO_wdt_set_heartbeat(heartbeat)) { > > iTCO_wdt_set_heartbeat(WATCHDOG_HEARTBEAT); > > - printk(KERN_INFO PFX > > - "timeout value out of range, using %d\n", > > heartbeat); > > + pr_info("timeout value out of range, using %d\n", > > heartbeat); > > } > > > > ret = misc_register(&iTCO_wdt_miscdev); > > if (ret != 0) { > > - printk(KERN_ERR PFX > > - "cannot register miscdev on minor=%d > > (err=%d)\n", > > + pr_err("cannot register miscdev on minor=%d > > (err=%d)\n", > > WATCHDOG_MINOR, > > ret); > > goto unreg_region; > > } > > > > - printk(KERN_INFO PFX "initialized. heartbeat=%d sec > > (nowayout=%d)\n", > > + pr_info("initialized. heartbeat=%d sec (nowayout=%d)\n", > > heartbeat, > > nowayout); > > > > return 0; > > > > unreg_region: > > - release_region(TCOBASE, 0x20); > > + release_resource(iTCO_wdt_private.tco_res); > > unreg_smi_en: > > - release_region(SMI_EN, 4); > > + release_resource(iTCO_wdt_private.tco_res); > > This doesn't look correct - you release tco_res twice. smi_res ? Also, a release for gcs_res is currently missing here... > > > out_unmap: > > if (iTCO_wdt_private.iTCO_version == 2) > > iounmap(iTCO_wdt_private.gcs); > > out: > > - iTCO_wdt_private.ACPIBASE = 0; > > - return ret; > > -} > > - -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/