Minor cleanup of Documentation/tipar.txt.
Signed-off-by: James Nelson <[email protected]>
diff -urN --exclude='*~' linux-2.6.9-original/Documentation/tipar.txt linux-2.6.9/Documentation/tipar.txt
--- linux-2.6.9-original/Documentation/tipar.txt 2004-10-18 17:53:06.000000000 -0400
+++ linux-2.6.9/Documentation/tipar.txt 2004-11-03 10:54:22.532837902 -0500
@@ -4,7 +4,7 @@
Author: Romain Lievin
-Homepage: http://lpg.ticalc.org/prj_dev
+Homepage: http://lpg.ticalc.org/prj_tidev/index.html
INTRODUCTION:
@@ -12,31 +12,30 @@
This is a driver for the very common home-made parallel link cable, a cable
designed for connecting TI8x/9x graphing calculators (handhelds) to a computer
or workstation (Alpha, Sparc). Given that driver is built on parport, the
-parallel port abstraction layer, this driver is independent of the platform.
+parallel port abstraction layer, this driver is architecture-independent.
It can also be used with another device plugged on the same port (such as a
-ZIP drive). I have a 100MB ZIP and both of them work fine !
+ZIP drive). I have a 100MB ZIP and both of them work fine!
If you need more information, please visit the 'TI drivers' homepage at the URL
above.
WHAT YOU NEED:
-A TI calculator of course and a program capable to communicate with your
-calculator.
-TiLP will work for sure (since I am his developer !). yal92 may be able to use
+A TI calculator and a program capable of communicating with your calculator.
+
+TiLP will work for sure (since I am its developer!). yal92 may be able to use
it by changing tidev for tipar (may require some hacking...).
HOW TO USE IT:
You must have first compiled parport support (CONFIG_PARPORT_DEV): either
compiled in your kernel, either as a module.
-This driver supports the new device hierarchy (devfs).
-Next, (as root) from your appropriate modules directory (lib/modules/2.5.XX):
+Next, (as root):
modprobe parport
- insmod tipar.o
+ modprobe tipar
If it is not already there (it usually is), create the device:
@@ -47,14 +46,14 @@
You will have to set permissions on this device to allow you to read/write
from it:
- chmod 666 /dev/tipar?
+ chmod 666 /dev/tipar[0..2]
Now you are ready to run a linking program such as TiLP. Be sure to configure
it properly (RTFM).
MODULE PARAMETERS:
- You can set these with: insmod tipar NAME=VALUE
+ You can set these with: modprobe tipar NAME=VALUE
There is currently no way to set these on a per-cable basis.
NAME: timeout
@@ -66,11 +65,12 @@
NAME: delay
TYPE: integer
DEFAULT: 10
- DESC: Inter-bit delay in micro-seconds. An lower value gives an higher data
+ DESC: Inter-bit delay in micro-seconds. A lower value gives an higher data
rate but makes transmission less reliable.
These parameters can be changed at run time by any program via ioctl(2) calls
-as listed in ./include/linux/ticable.h
+as listed in ./include/linux/ticable.h.
+
Rather than write 50 pages describing the ioctl() and so on, it is
perhaps more useful you look at ticables library (dev_link.c) that demonstrates
how to use them, and demonstrates the features of the driver. This is