Hi, all
I am using 2.6.11 on S3C2410 ARM platform.
I am using NFS for test...
When booting, it stop at -- Freeing init memory: 96K
My root filesystem is for 2.4.18, but I think it can be boot for 2.6.11
Thanks.
My .config file is attached.
-------------------------------
vivi> param set linux_cmd_line "noinitrd console=ttySAC0 init=/linuxrc
root=/de"Change linux command line to "noinitrd console=ttySAC0
init=/linuxrc root=/dev/"vivi> param save
Found block size = 0x0000c000
Erasing... ... done
Writing... ... done
Written 49152 bytes
Saved vivi private data
vivi> boot
Copy linux kernel from 0x00030000 to 0x30008000, size = 0x001d0000 ... done
zImage magic = 0x016f2818
Setup linux parameters at 0x30000100
linux command line is: "noinitrd console=ttySAC0 init=/linuxrc
root=/dev/nfs nf"MACH_TYPE = 193
NOW, Booting Linux......
Uncompressing Linux.............................................................Linux
version 2.6.11 ([email protected]) (gcc version 3.4.1) #26
Thu A5CPU: ARM920Tid(wb) [41129200] revision 0 (ARMv4T)
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
Machine: SMDK2410
ATAG_INITRD is deprecated; please update your bootloader.
Memory policy: ECC disabled, Data cache writeback
CPU S3C2410 (id 0x32410000)
S3C2410: core 200.000 MHz, memory 100.000 MHz, peripheral 50.000 MHz
S3C2410 Clock control, (c) 2004 Simtec Electronics
Built 1 zonelists
Kernel command line: noinitrd console=ttySAC0 init=/linuxrc
root=/dev/nfs nfsrofirq: clearing pending ext status 00000100
irq: clearing subpending status 00000003
irq: clearing subpending status 00000002
PID hash table entries: 512 (order: 9, 8192 bytes)
timer tcon=00000000, tcnt a2c1, tcfg 00000200,00000000, usec 00001eb8
Console: colour dummy device 80x30
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 64MB = 64MB total
Memory: 62336KB available (1818K code, 543K data, 96K init)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
S3C2410: Initialising architecture
S3C2410 DMA Driver, (c) 2003-2004 Simtec Electronics
DMA channel 0 at c4800000, irq 33
DMA channel 1 at c4800040, irq 34
DMA channel 2 at c4800080, irq 35
DMA channel 3 at c48000c0, irq 36
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
devfs: 2004-01-31 Richard Gooch ([email protected])
devfs: devfs_debug: 0x0
devfs: boot_options: 0x1
Initializing Cryptographic API
Real Time Clock Driver v1.12
S3C2410 RTC, (c) 2004 Simtec Electronics
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
s3c2410_serial0 at MMIO 0x50000000 (irq = 70) is a S3C2410
s3c2410_serial1 at MMIO 0x50004000 (irq = 73) is a S3C2410
s3c2410_serial2 at MMIO 0x50008000 (irq = 76) is a S3C2410
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
nbd: registered device at major 43
Cirrus Logic CS8900A driver for Linux (Modified for SMDK2410)
eth0: CS8900A rev E at 0xe0000300 irq=53, no eeprom , addr: 08: 0:3E:26:0A:5B
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
ide-floppy driver 0.99.newide
S3C2410 NAND Driver, (c) 2004 Simtec Electronics
s3c2410-nand: mapped registers at c4a00000
s3c2410-nand: timing: Tacls 10ns, Twrph0 40ns, Twrph1 10ns
NAND device: Manufacturer ID: 0xec, Chip ID: 0x76 (Samsung NAND 64MiB
3,3V 8-bi)NAND_ECC_NONE selected by board driver. This is not
recommended !!
Scanning device for bad blocks
Creating 5 MTD partitions on "NAND 64MiB 3,3V 8-bit":
0x00000000-0x00020000 : "vivi"
mtd: Giving out device 0 to vivi
0x00020000-0x00030000 : "param"
mtd: Giving out device 1 to param
0x00030000-0x001f0000 : "kernel"
mtd: Giving out device 2 to kernel
0x00200000-0x00400000 : "root"
mtd: Giving out device 3 to root
0x00400000-0x04000000 : "user"
mtd: Giving out device 4 to user
mice: PS/2 mouse device common for all mice
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
NET: Registered protocol family 1
IP-Config: Complete:
device=eth0, addr=192.168.16.155, mask=255.255.255.0, gw=192.168.16.122,
host=192.168.16.155, domain=, nis-domain=(none),
bootserver=192.168.16.122, rootserver=192.168.16.122, rootpath=
Looking up port of RPC 100003/2 on 192.168.16.122
Looking up port of RPC 100005/1 on 192.168.16.122
VFS: Mounted root (nfs filesystem).
Mounted devfs on /dev
Freeing init memory: 96K <<<---------- Stop here.
--
jeanwelly
Email: [email protected]
China