This display the following code extract as a code block instead of a
normal paragraph.
Signed-off-by: Yoann Congal <[email protected]>
---
Documentation/trace/kprobetrace.rst | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/trace/kprobetrace.rst b/Documentation/trace/kprobetrace.rst
index 5c49cdc8f8323..febfd3792854f 100644
--- a/Documentation/trace/kprobetrace.rst
+++ b/Documentation/trace/kprobetrace.rst
@@ -161,11 +161,11 @@ You can add and enable new kprobe events when booting up the kernel by
"kprobe_event=" parameter. The parameter accepts a semicolon-delimited
kprobe events, which format is similar to the kprobe_events.
The difference is that the probe definition parameters are comma-delimited
-instead of space. For example, adding myprobe event on do_sys_open like below
+instead of space. For example, adding myprobe event on do_sys_open like below::
p:myprobe do_sys_open dfd=%ax filename=%dx flags=%cx mode=+4($stack)
-should be below for kernel boot parameter (just replace spaces with comma)
+should be below for kernel boot parameter (just replace spaces with comma)::
p:myprobe,do_sys_open,dfd=%ax,filename=%dx,flags=%cx,mode=+4($stack)
--
2.30.2