The driver shutdown callback (which sends EDL_SOC_RESET to the device
over serdev) should not be invoked when HCI device is not open (e.g. if
hci_dev_open_sync() failed), because the serdev and its TTY are not open
either. Also skip this step if device is powered off
(qca_power_shutdown()).
Fixes: 7e7bbddd029b ("Bluetooth: hci_qca: Fix qca6390 enable failure after warm reboot")
Cc: <[email protected]>
Signed-off-by: Krzysztof Kozlowski <[email protected]>
---
drivers/bluetooth/hci_qca.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 6eddc23e49d9..3325c8be66f8 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -2164,10 +2164,17 @@ static void qca_serdev_shutdown(struct device *dev)
int timeout = msecs_to_jiffies(CMD_TRANS_TIMEOUT_MS);
struct serdev_device *serdev = to_serdev_device(dev);
struct qca_serdev *qcadev = serdev_device_get_drvdata(serdev);
+ struct hci_uart *hu = &qcadev->serdev_hu;
+ struct hci_dev *hdev = hu->hdev;
+ struct qca_data *qca = hu->priv;
const u8 ibs_wake_cmd[] = { 0xFD };
const u8 edl_reset_soc_cmd[] = { 0x01, 0x00, 0xFC, 0x01, 0x05 };
if (qcadev->btsoc_type == QCA_QCA6390) {
+ if (test_bit(QCA_BT_OFF, &qca->flags) || \
+ !test_bit(HCI_RUNNING, &hdev->flags))
+ return;
+
serdev_device_write_flush(serdev);
ret = serdev_device_write_buf(serdev, ibs_wake_cmd,
sizeof(ibs_wake_cmd));
--
2.34.1