Return-Path: MIME-Version: 1.0 In-Reply-To: References: <4C8A3537.2010606@openbossa.org> <4C8A758B.1060708@openbossa.org> Date: Fri, 10 Sep 2010 18:03:18 -0300 Message-ID: Subject: Re: set LE advertise not working... From: Claudio Takahasi To: Anderson Lizardo Cc: Pavan Savoy , Anderson Briglia , linux-bluetooth@vger.kernel.org Content-Type: text/plain; charset=UTF-8 Sender: linux-bluetooth-owner@vger.kernel.org List-ID: On Fri, Sep 10, 2010 at 5:35 PM, Anderson Lizardo wrote: > On Fri, Sep 10, 2010 at 3:01 PM, Pavan Savoy wrote: >> No, I don't suppose my controller was in a advertising state.. even if >> it was why the return 0x0c? (command disallowed ..) >> >> I wanted to know whether you have some HCI-VS commands which sort of >> enable the LE (AMP/radio/controller) ? >> Is it only then the leadv command works? Or does it just works right-away. >> I have one of those all in 1 chips.. bt/fm-rx-tx/gps so I am wondering >> should I do something to enable BLE and is it some sort of un-spoken >> standard? > > Does LE scan work for this same hardware? > > Do you have some windows software to test this hardware ? if so, you > can try putting one device in advertise mode there , then attempt > lescan on the other (from linux)... If it works, most probably the > hardware might require some initialization... > > At least some hardware requires firmware upload and vendor specific > one-time initialization which (I think) is out of scope for hciconfig. > > Regards, > -- > Anderson Lizardo > OpenBossa Labs - INdT > Manaus - Brazil > -- > To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at  http://vger.kernel.org/majordomo-info.html > Hi All, I noticed that some LE hardwares don't allow to enable scanning or advertising when inquiry scan and/or page scan are enabled. Try to disable it using hciconfig or the D-Bus method before to start LE operations. Regards, Claudio.