Return-Path: <cyrus@holtmann.org>
MIME-Version: 1.0
In-Reply-To: <AANLkTi=v3ZbVv2PkgCnSKxMRBPmbZCM5JA+bBXfDEd5x@mail.gmail.com>
References: <AANLkTikJFwwjs53_2F6NuBd-e00p1AnYahPMwYNgrveE@mail.gmail.com>
	<4C8A3537.2010606@openbossa.org>
	<AANLkTin02sOL89MuUhWe1_nOg4umytfJKRfc=Z_dhpRq@mail.gmail.com>
	<4C8A758B.1060708@openbossa.org>
	<AANLkTi=v3ZbVv2PkgCnSKxMRBPmbZCM5JA+bBXfDEd5x@mail.gmail.com>
Date: Fri, 10 Sep 2010 16:35:20 -0400
Message-ID: <AANLkTi=8nM_nh_4riZaCj77LLzaqRie0dPjGswqpSFz-@mail.gmail.com>
Subject: Re: set LE advertise not working...
From: Anderson Lizardo <anderson.lizardo@openbossa.org>
To: Pavan Savoy <pavan_savoy@sify.com>
Cc: Anderson Briglia <anderson.briglia@openbossa.org>,
	linux-bluetooth@vger.kernel.org
Content-Type: text/plain; charset=ISO-8859-1
Sender: linux-bluetooth-owner@vger.kernel.org
List-ID: <linux-bluetooth.vger.kernel.org>

On Fri, Sep 10, 2010 at 3:01 PM, Pavan Savoy <pavan_savoy@sify.com> wrote:
> No, I don't suppose my controller was in a advertising state.. even if
> it was why the return 0x0c? (command disallowed ..)
>
> I wanted to know whether you have some HCI-VS commands which sort of
> enable the LE (AMP/radio/controller) ?
> Is it only then the leadv command works? Or does it just works right-away.
> I have one of those all in 1 chips.. bt/fm-rx-tx/gps so I am wondering
> should I do something to enable BLE and is it some sort of un-spoken
> standard?

Does LE scan work for this same hardware?

Do you have some windows software to test this hardware ? if so, you
can try putting one device in advertise mode there , then attempt
lescan on the other (from linux)... If it works, most probably the
hardware might require some initialization...

At least some hardware requires firmware upload and vendor specific
one-time initialization which (I think) is out of scope for hciconfig.

Regards,
-- 
Anderson Lizardo
OpenBossa Labs - INdT
Manaus - Brazil