Return-Path: From: Marcel Holtmann To: linux-bluetooth@vger.kernel.org Subject: [PATCH] doc: Add management command for adding devices for passive scanning Date: Sun, 29 Jun 2014 11:49:16 +0200 Message-Id: <1404035356-37352-1-git-send-email-marcel@holtmann.org> Sender: linux-bluetooth-owner@vger.kernel.org List-ID: --- doc/mgmt-api.txt | 62 ++++++++++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 62 insertions(+) diff --git a/doc/mgmt-api.txt b/doc/mgmt-api.txt index d329d4a66d9c..d428f7718512 100644 --- a/doc/mgmt-api.txt +++ b/doc/mgmt-api.txt @@ -1866,6 +1866,68 @@ Get Clock Information Command Invalid Index +Add Device Command +================== + + Command Code: 0x0034 + Controller Index: + Command Parameters: Address (6 Octets) + Address_Type (1 Octet) + Action (1 Octet) + Return Parameters: + + This command is used to add a device to the action list. The + action list allows scanning for devices and auto-connection + to known devices. + + Possible values for the Action parameter: + 0 Background scan for device + 1 Auto-connect device + + With the Action 0, when the device is found, a new Device Found + event will be send indicating this device is available. Devices + using direct advertising will be connected. + + With the Action 1, when the device is found, it will be connected + and if successful a Device Connected event will be send. + + This command can be used when the controller is not powered and + all settings will be programmed once powered. + + This command generates a Command Complete event on success or + a Command Status event on failure. + + Possible errors: Busy + Invalid Parameters + Invalid Index + + +Remove Device Command +===================== + + Command Code: 0x0035 + Controller Index: + Command Parameters: Address (6 Octets) + Address_Type (1 Octet) + Return Parameters: + + This command is used to remove a device from the action list + previously added by using the Add Device command. + + When the Address parameter is 00:00:00:00:00:00, then all + previously added devices wil be removed. + + This command can be used when the controller is not powered and + all settings will be programmed once powered. + + This command generates a Command Complete event on success or + a Command Status event on failure. + + Possible errors: Busy + Invalid Parameters + Invalid Index + + Command Complete Event ====================== -- 1.9.3