Return-Path: From: Jaganath Kanakkassery To: linux-bluetooth@vger.kernel.org Cc: Jaganath Kanakkassery Subject: [PATCH 2/3 v1] doc/mgmt-api: Add support for Set default Phy command Date: Thu, 16 Nov 2017 10:50:45 +0530 Message-Id: <1510809645-23019-1-git-send-email-jaganathx.kanakkassery@intel.com> Sender: linux-bluetooth-owner@vger.kernel.org List-ID: --- doc/mgmt-api.txt | 38 ++++++++++++++++++++++++++++++++++++++ 1 file changed, 38 insertions(+) diff --git a/doc/mgmt-api.txt b/doc/mgmt-api.txt index 69e84cd..b59bf0c 100644 --- a/doc/mgmt-api.txt +++ b/doc/mgmt-api.txt @@ -2940,9 +2940,47 @@ Get PHY Information Command LE 1M TX and LE 1M RX would be supported by default. This command is only available for LE capable controllers. + It will return Not Supported otherwise. + + Possible errors: Not Supported + Invalid Index + +Set Default PHY Command +========================== + + Command Code: 0x0044 + Controller Index: + Command Parameters: Default_phy (1 Octet) + Return Parameters: Current_phys (1 Octet) + + This command is used to set the default phy to the controller. + + This will be stored and used for all the subsequent scanning + and connection initiation. + + Prior to this, Get PHY information Command should be called + to retrieve the supported phys by the controller. If default_phy + has phy not supported by the controller (not there in supported_phys) + then Invalid Parameters will be returned. + + This can be called at any point to change the preferred phys. + + Default_phy is a bitmask with the following bits. + 0 LE 1M TX + 1 LE 1M RX + 2 LE 2M TX + 3 LE 2M RX + 4 LE CODED TX + 5 LE CODED RX + + This command generates a Command Complete event on success + or a Command Status event on failure. + + This command is only available for LE capable controllers. It will return Not Supported otherwise. Possible errors: Not Supported + Invalid Parameters Invalid Index Command Complete Event -- 2.7.4