Return-Path: From: Jaganath Kanakkassery To: linux-bluetooth@vger.kernel.org Cc: Jaganath Kanakkassery Subject: [v5 PATCH 2/3] doc/mgmt-api: Add support for Set Phy Configuration command Date: Wed, 28 Feb 2018 13:19:10 +0530 Message-Id: <1519804151-4850-2-git-send-email-jaganathx.kanakkassery@intel.com> In-Reply-To: <1519804151-4850-1-git-send-email-jaganathx.kanakkassery@intel.com> References: <1519804151-4850-1-git-send-email-jaganathx.kanakkassery@intel.com> Sender: linux-bluetooth-owner@vger.kernel.org List-ID: This also adds PHY Configuration Changed Event. --- doc/mgmt-api.txt | 52 ++++++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 52 insertions(+) diff --git a/doc/mgmt-api.txt b/doc/mgmt-api.txt index c07c48c..628ff18 100644 --- a/doc/mgmt-api.txt +++ b/doc/mgmt-api.txt @@ -2940,9 +2940,46 @@ Get PHY Configuration Command LE 1M TX and LE 1M RX would be supported by default. This command is only available for LE capable controllers. + It will return Not Supported otherwise. + + Possible errors: Not Supported + Invalid Index + +Set PHY Configuration Command +============================= + + Command Code: 0x0044 + Controller Index: + Command Parameters: Default_phys (2 Octet) + Return Parameters: + + This command is used to set the default phy to the controller. + + This will be stored and used for all the subsequent scanning + and connection initiation. + + The list of supported PHYs can be retrieved via the + Get PHY Configuration command. Selecting unsupported PHYs will + result in an Invalid Parameters error. + + This can be called at any point to change the preferred PHYs. + + Default_phy is a bitmask with the following bits. + 0 LE 1M TX + 1 LE 1M RX + 2 LE 2M TX + 3 LE 2M RX + 4 LE CODED TX + 5 LE CODED RX + + This command generates a Command Complete event on success + or a Command Status event on failure. + + This command is only available for LE capable controllers. It will return Not Supported otherwise. Possible errors: Not Supported + Invalid Parameters Invalid Index Command Complete Event @@ -3810,3 +3847,18 @@ Extended Controller Information Changed Event The event will only be sent to management sockets other than the one through which the change was triggered. + +PHY Configuration Changed Event +=============================== + + Event Code: 0x0026 + Controller Index: + Event Parameters: Selected_phys (2 Octets) + + This event indicates that default PHYs have been updated. + + This event will only be used after Set PHY Configuration + command has been used at least once. + + The event will only be sent to management sockets other than the + one through which the change was triggered. -- 2.7.4