Return-Path: From: Stefan Wahren To: Loic Poulain , =?UTF-8?q?Fr=C3=A9d=C3=A9ric=20Danis?= , Marcel Holtmann , Johan Hedberg , Eric Anholt , Rob Herring , Mark Rutland Cc: Lukas Wunner , Phil Elwell , Florian Fainelli , linux-bluetooth@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-rpi-kernel@lists.infradead.org, devicetree@vger.kernel.org, Stefan Wahren Subject: [PATCH 2/4] ARM: dts: bcm283x: Apply pull settings to Zero W relevant groups Date: Sun, 25 Feb 2018 15:10:53 +0100 Message-Id: <1519567855-26105-3-git-send-email-stefan.wahren@i2se.com> In-Reply-To: <1519567855-26105-1-git-send-email-stefan.wahren@i2se.com> References: <1519567855-26105-1-git-send-email-stefan.wahren@i2se.com> List-ID: Instead of keeping the firmware's pull settings, we better apply them via the devicetree pin control. Start with the RPi Zero W relevant first to keep the effort low. Signed-off-by: Stefan Wahren --- arch/arm/boot/dts/bcm283x.dtsi | 3 +++ 1 file changed, 3 insertions(+) diff --git a/arch/arm/boot/dts/bcm283x.dtsi b/arch/arm/boot/dts/bcm283x.dtsi index 8d9a0df..1a50b67 100644 --- a/arch/arm/boot/dts/bcm283x.dtsi +++ b/arch/arm/boot/dts/bcm283x.dtsi @@ -223,6 +223,7 @@ gpclk2_gpio43: gpclk2_gpio43 { brcm,pins = <43>; brcm,function = ; + brcm,pull = ; }; i2c0_gpio0: i2c0_gpio0 { @@ -335,10 +336,12 @@ uart0_ctsrts_gpio30: uart0_ctsrts_gpio30 { brcm,pins = <30 31>; brcm,function = ; + brcm,pull = ; }; uart0_gpio32: uart0_gpio32 { brcm,pins = <32 33>; brcm,function = ; + brcm,pull = ; }; uart0_gpio36: uart0_gpio36 { brcm,pins = <36 37>; -- 2.7.4