Received-SPF: pass (google.com: domain of linux-bluetooth-owner@vger.kernel.org designates 2620:137:e000::1:20 as permitted sender) client-ip=2620:137:e000::1:20;
Message-ID: <b8b21831-8078-fb53-d4be-9feb6138b19d@linaro.org>
Date:   Wed, 22 Jun 2022 10:33:48 +0300
MIME-Version: 1.0
User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:91.0) Gecko/20100101
 Thunderbird/91.10.0
Subject: Re: [PATCH v1 0/3] WAR to handle WCN6750 hardware issue
Content-Language: en-GB
To:     Balakrishna Godavarthi <quic_bgodavar@quicinc.com>,
        agross@kernel.org, robh+dt@kernel.org, bjorn.andersson@linaro.org,
        linux-arm-msm@vger.kernel.org, devicetree@vger.kernel.org,
        linux-kernel@vger.kernel.org, marcel@holtmann.org,
        johan.hedberg@gmail.com
Cc:     mka@chromium.org, linux-bluetooth@vger.kernel.org,
        quic_hemantg@quicinc.com, quic_saluvala@quicinc.com,
        quic_rjliao@quicinc.com, mcchou@chromium.org
References: <1651228073-1999-1-git-send-email-quic_bgodavar@quicinc.com>
From:   Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
In-Reply-To: <1651228073-1999-1-git-send-email-quic_bgodavar@quicinc.com>
Content-Type: text/plain; charset=UTF-8; format=flowed
Content-Transfer-Encoding: 7bit
Precedence: bulk

On 29/04/2022 13:27, Balakrishna Godavarthi wrote:
> On WCN6750 sometimes observed AON power source takes 100ms
> time to fully discharge voltage during OFF. As WCN6750 is
> combo chip for WLAN and BT. If any of the tech area ON is
> triggered during discharge phase, it fails to turn ON.
> To overcome this hardware issue, During BT ON, driver check
> for WLAN_EN pin status. If it high, it will pull BT_EN to high
> immediately else it will wait for 100ms assuming WLAN was just
> powered OFF and then BT_EN will be pulled to high.

Ugh. This adds another point to support separate power sequencer device 
for WiFi+BT devices. Let me refresh my last patchset, so that we can 
implement it as a part of common code, rather than hacking hci_qca on 
and on.

> 
> Balakrishna Godavarthi (3):
>    dt-bindings: net: bluetooth: Add wlan-gpio entry for wcn6750
>    arm64: dts: qcom: sc7280: Add wlan enable gpio to bluetooth node
>    Bluetooth: hci_qca: WAR to handle WCN6750 HW issue
> 
>   .../bindings/net/qualcomm-bluetooth.yaml           |  6 +++++
>   arch/arm64/boot/dts/qcom/sc7280-idp.dtsi           |  1 +
>   drivers/bluetooth/hci_qca.c                        | 30 +++++++++++++++++-----
>   3 files changed, 31 insertions(+), 6 deletions(-)
> 


-- 
With best wishes
Dmitry