2009-07-15 15:51:57

by Hibiki Kanzaki

[permalink] [raw]
Subject: Simplest PAN Config?

am trying to configure the most basic point-to-point
Bluetooth IP network. I have two computers with the
same model of USB Bluetooth (2.0, EDR, etc) dongle
attached to them. I am running Ubuntu Jaunty on both
computers. I do not have GUI (desktop) applications
installed on them. Ubuntu Jaunty comes with bluez
4.32. All I want is the most simple possible
configuration... the minimal amount of configuration
necessary to be able to have applications one the
computers interact using TCP/UDP/IP via Linux network
devices. I do not care about forwarding packets to
other hosts, or about encryption or authentication,
etc; I am trying to start with the equivalent of
connecting two ethernet cards.

When I connect the Bluetooth dongle, I get a
"pan0" linux network device on which I can perform
commands like "ip link set ...", "ip addr add ...",
etc. They all succeed and I can ping the local
device address. Each computer can do this local
interaction with the pan0 network device. I can
also do "hcitool scan" to see the remote Bluetooth
devices, and I can do "hcitool info", "l2ping", etc.
The device advertises "PAN", "GN", etc, services,
so I do not think it is a limitation of devices.

So on each side I can see and interact with the
local pan0 network device, and I can use the
"hciconfig" and "hcitool" to get some degree of
interaction between the two computers. But if I
configure the pan0 devices as I would a regular
network device, including adding ARP entries which
have the layer2 address of the remote pan0, I cannot
seem to get the IP layer of the Linux kernel to
actually talk to the remote Bluetooth device using
the Linux kernel network facilities. If I run
"hcidump", I do not see anything happening if I try
to ping the remote Bluetooth interface.

Am I missing something simple? I am not having any
luck finding how to do what seems like it should be
trivial... plugin a Bluetooth dongle on each side
and be able to send IP packets from one to the other
using the Linux network devices. I am clueless
about the details of Bluetooth protocols. If I
cannot get the networking working this way, I would
be willing to have the devices connected to each
other as a serial port, and then just run ppp over
that, although I have no idea how to do that, since
I have never tried or looked into it.