Return-Path: Date: Fri, 13 Aug 2004 15:34:12 -0700 To: Marcel Holtmann Cc: BlueZ Mailing List , Steven Singer Subject: Re: CSR firmware question... Message-ID: <20040813223412.GA3158@bougret.hpl.hp.com> Reply-To: jt@hpl.hp.com References: <20040813002514.GA21388@bougret.hpl.hp.com> <1092385877.28711.185.camel@pegasus> <20040813163736.GC22763@bougret.hpl.hp.com> <1092416234.28711.256.camel@pegasus> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii In-Reply-To: <1092416234.28711.256.camel@pegasus> From: Jean Tourrilhes List-ID: On Fri, Aug 13, 2004 at 06:57:14PM +0200, Marcel Holtmann wrote: > Hi Jean, > > > > The D-Link dongle DBT-120 (Rev B3) can be updated using the Apple > > > firmware update file. After that it will be HCI 18.1 with default boot > > > mode set to HID. > > > > This is exactly what I did. I have a rev B3, and I used Apple > > file. > > What do you mean default boot set to HID ? I look similar to > > what I'm seeing. > > try running hid2hci :) Try, and it won't work, the device doesn't even have a control pipe anymore. Dead. > If this does not work, show us /proc/bus/usb/devices. T: Bus=01 Lev=01 Prnt=01 Port=01 Cnt=02 Dev#= 5 Spd=12 MxCh= 0 D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1 P: Vendor=0a12 ProdID=1000 Rev=12.41 C:* #Ifs= 2 Cfg#= 1 Atr=e0 MxPwr= 0mA I: If#= 0 Alt= 0 #EPs= 1 Cls=03(HID ) Sub=01 Prot=01 Driver=(none) E: Ad=81(I) Atr=03(Int.) MxPS= 16 Ivl=1ms I: If#= 1 Alt= 0 #EPs= 1 Cls=03(HID ) Sub=01 Prot=02 Driver=(none) E: Ad=82(I) Atr=03(Int.) MxPS= 16 Ivl=1ms (That's with 2.4.X. Under 2.6.X, I can't make sense of the usb stuff). > Regards > > Marcel Have fun... Jean