Return-Path: Subject: RE: [Bluez-devel] Cannot send through serial device rfcomm From: Marcel Holtmann To: Robert Wlaschin Cc: "'bluez-devel@lists.sourceforge.net'" In-Reply-To: References: Content-Type: text/plain Message-Id: <1128534858.5447.38.camel@localhost.localdomain> Mime-Version: 1.0 Sender: bluez-devel-admin@lists.sourceforge.net Errors-To: bluez-devel-admin@lists.sourceforge.net Reply-To: bluez-devel@lists.sourceforge.net List-Unsubscribe: , List-Id: BlueZ development List-Post: List-Help: List-Subscribe: , List-Archive: Date: Wed, 05 Oct 2005 19:54:18 +0200 Hi Robert, > much for the help thus far. Yes the rfcomm0 device is created: > This is the output from rfcomm; rfcomm0: 00:A0:96:0D:3B:80 channel 1 > closed, I have also seen it report [tty-attached] when I am attempting > to read/write/connect, but it says 'config' not 'open' > > So, I saw this error message: > > > HCI Event: Connect Complete (0x03) plen 11 > status 0x05 handle 41 bdaddr 00:A0:96:0D:3B:80 type ACL encrypt > 0x00 > Error: Authentication Failure this means that you provide the wrong link key. Delete all your link keys or set the device into pairing mode. > So I did this: hciconfig hci0 auth, but I still got the same error, so > I followed with this: hciconfig hci0 encrypt, but I still seem to be > getting the error message. This is a misconception. What activated security mode 3 and this is not helpful at all. Regards Marcel ------------------------------------------------------- This SF.Net email is sponsored by: Power Architecture Resource Center: Free content, downloads, discussions, and more. http://solutions.newsforge.com/ibmarch.tmpl _______________________________________________ Bluez-devel mailing list Bluez-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bluez-devel