Return-Path: Subject: Re: [Bluez-users] HCI Config returns Can't Init device From: Marcel Holtmann To: BlueZ Mailing List In-Reply-To: References: Content-Type: text/plain Message-Id: <1112008411.9016.11.camel@pegasus> Mime-Version: 1.0 Sender: bluez-users-admin@lists.sourceforge.net Errors-To: bluez-users-admin@lists.sourceforge.net Reply-To: bluez-users@lists.sourceforge.net List-Unsubscribe: , List-Id: BlueZ users List-Post: List-Help: List-Subscribe: , List-Archive: Date: Mon, 28 Mar 2005 13:13:31 +0200 Hi Hariharan, > i am using 2.4.18 kernel with the RFMD serial port bluetooth > module. i have ported the Bluez Stack and HCI_H4 protocol modules. The > RFMD device is get attached by > > hciattach /dev/ttyS0 swave 115200 flow > > the patch added in the hciattach.c is soft reset functionality > included before sending param acess command in SWAVE function and > after that reset again. This attaches my UART dongle with the HCI > layer. > > When i try to hciconfig uration i am getting the following errors. > > hciconfig hci0 up > > Can't init device hci0. Connection timed out(110) ERROR. > > But i could have functionality with Kernel 2.6. The HCI config works fine. > > Is there any patch to imply for the 2..4 kernel. you need at least use my 2.4.18-mh15 patch. However if the 2.6 kernel works then use it. Regards Marcel ------------------------------------------------------- SF email is sponsored by - The IT Product Guide Read honest & candid reviews on hundreds of IT Products from real users. Discover which products truly live up to the hype. Start reading now. http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click _______________________________________________ Bluez-users mailing list Bluez-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bluez-users