From: Fabio Baltieri Subject: [PATCH 1/6] crypto: ux500/hash: use readl on iomem addresses Date: Tue, 25 Jun 2013 10:54:44 +0200 Message-ID: <1372150489-25594-2-git-send-email-fabio.baltieri@linaro.org> References: <1372150489-25594-1-git-send-email-fabio.baltieri@linaro.org> Cc: linux-crypto@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org, Linus Walleij , Lee Jones , Fabio Baltieri To: Herbert Xu Return-path: In-Reply-To: <1372150489-25594-1-git-send-email-fabio.baltieri@linaro.org> Sender: linux-kernel-owner@vger.kernel.org List-Id: linux-crypto.vger.kernel.org Always use readl when reading memory mapped registers. Signed-off-by: Fabio Baltieri --- drivers/crypto/ux500/hash/hash_core.c | 20 ++++++++++---------- 1 file changed, 10 insertions(+), 10 deletions(-) diff --git a/drivers/crypto/ux500/hash/hash_core.c b/drivers/crypto/ux500/hash/hash_core.c index f89fe8a..154f437 100644 --- a/drivers/crypto/ux500/hash/hash_core.c +++ b/drivers/crypto/ux500/hash/hash_core.c @@ -473,12 +473,12 @@ static void hash_hw_write_key(struct hash_device_data *device_data, HASH_SET_DIN(&word, nwords); } - while (device_data->base->str & HASH_STR_DCAL_MASK) + while (readl(&device_data->base->str) & HASH_STR_DCAL_MASK) cpu_relax(); HASH_SET_DCAL; - while (device_data->base->str & HASH_STR_DCAL_MASK) + while (readl(&device_data->base->str) & HASH_STR_DCAL_MASK) cpu_relax(); } @@ -661,7 +661,7 @@ static void hash_messagepad(struct hash_device_data *device_data, if (index_bytes) HASH_SET_DIN(message, nwords); - while (device_data->base->str & HASH_STR_DCAL_MASK) + while (readl(&device_data->base->str) & HASH_STR_DCAL_MASK) cpu_relax(); /* num_of_bytes == 0 => NBLW <- 0 (32 bits valid in DATAIN) */ @@ -676,7 +676,7 @@ static void hash_messagepad(struct hash_device_data *device_data, (int)(readl_relaxed(&device_data->base->str) & HASH_STR_NBLW_MASK)); - while (device_data->base->str & HASH_STR_DCAL_MASK) + while (readl(&device_data->base->str) & HASH_STR_DCAL_MASK) cpu_relax(); } @@ -776,7 +776,7 @@ void hash_begin(struct hash_device_data *device_data, struct hash_ctx *ctx) /* HW and SW initializations */ /* Note: there is no need to initialize buffer and digest members */ - while (device_data->base->str & HASH_STR_DCAL_MASK) + while (readl(&device_data->base->str) & HASH_STR_DCAL_MASK) cpu_relax(); /* @@ -962,7 +962,7 @@ static int hash_dma_final(struct ahash_request *req) wait_for_completion(&ctx->device->dma.complete); hash_dma_done(ctx); - while (device_data->base->str & HASH_STR_DCAL_MASK) + while (readl(&device_data->base->str) & HASH_STR_DCAL_MASK) cpu_relax(); if (ctx->config.oper_mode == HASH_OPER_MODE_HMAC && ctx->key) { @@ -1060,7 +1060,7 @@ int hash_hw_final(struct ahash_request *req) req_ctx->state.index); } else { HASH_SET_DCAL; - while (device_data->base->str & HASH_STR_DCAL_MASK) + while (readl(&device_data->base->str) & HASH_STR_DCAL_MASK) cpu_relax(); } @@ -1189,7 +1189,7 @@ int hash_resume_state(struct hash_device_data *device_data, temp_cr = device_state->temp_cr; writel_relaxed(temp_cr & HASH_CR_RESUME_MASK, &device_data->base->cr); - if (device_data->base->cr & HASH_CR_MODE_MASK) + if (readl(&device_data->base->cr) & HASH_CR_MODE_MASK) hash_mode = HASH_OPER_MODE_HMAC; else hash_mode = HASH_OPER_MODE_HASH; @@ -1233,7 +1233,7 @@ int hash_save_state(struct hash_device_data *device_data, * actually makes sure that there isn't any ongoing calculation in the * hardware. */ - while (device_data->base->str & HASH_STR_DCAL_MASK) + while (readl(&device_data->base->str) & HASH_STR_DCAL_MASK) cpu_relax(); temp_cr = readl_relaxed(&device_data->base->cr); @@ -1242,7 +1242,7 @@ int hash_save_state(struct hash_device_data *device_data, device_state->din_reg = readl_relaxed(&device_data->base->din); - if (device_data->base->cr & HASH_CR_MODE_MASK) + if (readl(&device_data->base->cr) & HASH_CR_MODE_MASK) hash_mode = HASH_OPER_MODE_HMAC; else hash_mode = HASH_OPER_MODE_HASH; -- 1.8.2