From: Juuso Oikarinen <[email protected]>
In the NVS/INI-parameters for the driver/firmware there is the FEM
(front end module) selection option, which may configure the hardware FEM
via autodetection or manual selection. So far, there has been support for
manual selection only.
Add support for FEM autodetection.
Signed-off-by: Juuso Oikarinen <[email protected]>
---
drivers/net/wireless/wl12xx/wl1271_cmd.c | 21 +++++++++++++++++----
1 files changed, 17 insertions(+), 4 deletions(-)
diff --git a/drivers/net/wireless/wl12xx/wl1271_cmd.c b/drivers/net/wireless/wl12xx/wl1271_cmd.c
index 596e333..5d3e848 100644
--- a/drivers/net/wireless/wl12xx/wl1271_cmd.c
+++ b/drivers/net/wireless/wl12xx/wl1271_cmd.c
@@ -108,6 +108,8 @@ out:
int wl1271_cmd_general_parms(struct wl1271 *wl)
{
struct wl1271_general_parms_cmd *gen_parms;
+ struct wl1271_ini_general_params *gp = &wl->nvs->general_params;
+ bool answer = false;
int ret;
if (!wl->nvs)
@@ -119,13 +121,24 @@ int wl1271_cmd_general_parms(struct wl1271 *wl)
gen_parms->test.id = TEST_CMD_INI_FILE_GENERAL_PARAM;
- memcpy(&gen_parms->general_params, &wl->nvs->general_params,
- sizeof(struct wl1271_ini_general_params));
+ memcpy(&gen_parms->general_params, gp, sizeof(*gp));
- ret = wl1271_cmd_test(wl, gen_parms, sizeof(*gen_parms), 0);
- if (ret < 0)
+ if (gp->tx_bip_fem_auto_detect)
+ answer = true;
+
+ ret = wl1271_cmd_test(wl, gen_parms, sizeof(*gen_parms), answer);
+ if (ret < 0) {
wl1271_warning("CMD_INI_FILE_GENERAL_PARAM failed");
+ goto out;
+ }
+
+ gp->tx_bip_fem_manufacturer =
+ gen_parms->general_params.tx_bip_fem_manufacturer;
+ wl1271_debug(DEBUG_CMD, "FEM autodetect: %s, manufacturer: %d\n",
+ answer ? "auto" : "manual", gp->tx_bip_fem_manufacturer);
+
+out:
kfree(gen_parms);
return ret;
}
--
1.7.0.4