Since mt76_txq_send_burst routine can report a negative error code,
check the returned value before incrementing the number of transmitted
frames in mt76_txq_schedule_list routine.
Return -EBUSY directly if the device is in reset or in power management.
Fixes: 90fdc1717b186 ("mt76: use mac80211 txq scheduling")
Signed-off-by: Lorenzo Bianconi <[email protected]>
---
drivers/net/wireless/mediatek/mt76/tx.c | 15 ++++++++++-----
1 file changed, 10 insertions(+), 5 deletions(-)
diff --git a/drivers/net/wireless/mediatek/mt76/tx.c b/drivers/net/wireless/mediatek/mt76/tx.c
index b8fe8adc43a3..451ed60c6296 100644
--- a/drivers/net/wireless/mediatek/mt76/tx.c
+++ b/drivers/net/wireless/mediatek/mt76/tx.c
@@ -461,11 +461,11 @@ mt76_txq_schedule_list(struct mt76_phy *phy, enum mt76_txq_id qid)
int ret = 0;
while (1) {
+ int n_frames = 0;
+
if (test_bit(MT76_STATE_PM, &phy->state) ||
- test_bit(MT76_RESET, &phy->state)) {
- ret = -EBUSY;
- break;
- }
+ test_bit(MT76_RESET, &phy->state))
+ return -EBUSY;
if (dev->queue_ops->tx_cleanup &&
q->queued + 2 * MT_TXQ_FREE_THR >= q->ndesc) {
@@ -497,11 +497,16 @@ mt76_txq_schedule_list(struct mt76_phy *phy, enum mt76_txq_id qid)
}
if (!mt76_txq_stopped(q))
- ret += mt76_txq_send_burst(phy, q, mtxq);
+ n_frames = mt76_txq_send_burst(phy, q, mtxq);
spin_unlock_bh(&q->lock);
ieee80211_return_txq(phy->hw, txq, false);
+
+ if (unlikely(n_frames < 0))
+ return n_frames;
+
+ ret += n_frames;
}
return ret;
--
2.29.2