Hello ax200 folks,
I've been looking into how to set the ax200/ax210 NIC to use a specific
rateset. There is some debugfs hooks in the driver that appear to allow
this sort of behaviour, but they are not enabled because the ax210 firmware
uses firmware based rate-ctrl.
Is there any way to tell it to send with only a single rate for testing
purposes? My end goal is to do receiver sensitivity testing, so I need
a way to force the MCS, NSS, guard interval and other tx-rate related
settings.
Thanks,
Ben
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com