Return-path: Received: from c60.cesmail.net ([216.154.195.49]:44003 "EHLO c60.cesmail.net" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751350AbYFPDkm (ORCPT ); Sun, 15 Jun 2008 23:40:42 -0400 Subject: Re: Problem with master mode on BCM4318 From: Pavel Roskin To: Mark Roberts Cc: linux-wireless@vger.kernel.org In-Reply-To: References: Content-Type: text/plain Date: Sun, 15 Jun 2008 23:40:39 -0400 Message-Id: <1213587639.2469.10.camel@dv> (sfid-20080616_093323_086453_C5664731) Mime-Version: 1.0 Sender: linux-wireless-owner@vger.kernel.org List-ID: On Mon, 2008-06-16 at 12:24 +0900, Mark Roberts wrote: > I noticed the warning in the dmesg output about having old firmware > and I've followed the instructions on the web site to install it, but > it seems to make no difference. I still see the warning. > > I assume that I'm doing something wrong, but I cannot tell. You didn't write anything about the procedure you used to install the firmware, so it impossible for others to see what was wrong with it. Perhaps you should find where the original firmware is installed, move it away and make sure the new firmware appears there if you install it. > To be > honest, I don't find the documentation on linuxwireless.org to be very > clear or well-presented. It seems to be written primarily for > developers, not end-users as the site advertises. You didn't specify which exactly instructions you followed. There is more than one page there. Master mode support is definitely not intended for the end users at this point. > At this point, I'm stuck. Any suggestions? Be specific. -- Regards, Pavel Roskin