MIME-Version: 1.0
In-Reply-To: <4A696D33.8050606@promwad.com>
References: <4A682BBD.90101@promwad.com> <43e72e890907230917w226c4697v41f907623e5f7d8@mail.gmail.com>
	<4A696D33.8050606@promwad.com>
From: "Luis R. Rodriguez" <mcgrof@gmail.com>
Date: Fri, 24 Jul 2009 08:24:28 -0700
Message-ID: <43e72e890907240824n5bcff378m1278eb948055a9a5@mail.gmail.com>
Subject: Re: WPA2, compat-wireless-2.6.31-rc3, kernel 2.6.28 - rtl8187 -
	association works but no ping
To: ivan.kuten@promwad.com
Cc: linux-wireless@vger.kernel.org
Content-Type: text/plain; charset=UTF-8
Sender: linux-wireless-owner@vger.kernel.org

On Fri, Jul 24, 2009 at 1:13 AM, Ivan Kuten<ivan.kuten@promwad.com> wrote:
>> On Thu, Jul 23, 2009 at 2:22 AM, Ivan Kuten<ivan.kuten@promwad.com> wrote:
>>> compat-wireless-2.6.31-rc3
>>
>> compat-wireless-2.6.31-rc4 is out, please try that.
>>
>>   Luis
>>
>
> Here is what I get for compat-wireless-2.6.31-rc4:
>
>
> <6>cfg80211: Using static regulatory domain info
> <6>cfg80211: Regulatory domain: US
> <6>     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
> <6>     (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm)
> <6>     (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
> <6>     (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
> <6>     (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
> <6>     (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
> <6>     (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
> <6>usb 1-1: new high speed USB device using isp1761 and address 2
> <6>cfg80211: Calling CRDA for country: US
> <6>usbcore: registered new interface driver rtl8187
> <6>usb 1-1: configuration #1 chosen from 1 choice
> <6>hub 1-1:1.0: USB hub found
> <6>hub 1-1:1.0: 3 ports detected
> <6>usb 1-1.1: new high speed USB device using isp1761 and address 3
> <6>usb 1-1.1: configuration #1 chosen from 1 choice
> <7>phy0: Selected rate control algorithm 'minstrel'
> <6>phy0: hwaddr 00277080, RTL8187vB (default) V1 + rtl8225z2
> <7>phy0: device now idle
> <7>phy0: device no longer idle - scanning
> <7>phy0: device now idle
> <7>phy0: device no longer idle - in use
> <7>wlan0: authenticate with AP 01a4b568
> <7>wlan0: authenticated
> <7>wlan0: associate with AP 01a4b568
> <7>wlan0: RX AssocResp from 003e101a (capab=0x411 status=0 aid=2)
> <7>wlan0: associated
> <7>phy0: Allocated STA 002fbfc4
> <7>phy0: Inserted STA 002fbfc4
> <7>wlan0: switched to short slot time (BSSID=01a4b568)

This looks peachy.

> iwconfig output:
>
> lo        no wireless extensions.
>
> eth0      no wireless extensions.
>
> wmaster0  no wireless extensions.
>
> wlan0     IEEE 802.11bg  ESSID:"ACORP"
>          Mode:Managed  Frequency:2.462 GHz  Access Point: 00:02:72:74:AC:85
>          Bit Rate=1 Mb/s   Tx-Power=27 dBm
>          Retry  long limit:7   RTS thr:off   Fragment thr:off
>          Encryption key:2BAC-63B9-5D99-CF9A-4D39-079F-BB55-5D39 [2]
>          Power Management:off
>          Link Quality=61/70  Signal level=-49 dBm
>          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>          Tx excessive retries:0  Invalid misc:0   Missed beacon:0
>
>
> ifconfig:
>
> eth0      Link encap:Ethernet  HWaddr 02:80:AD:20:31:EB
>          inet addr:192.168.5.1  Bcast:192.168.5.255  Mask:255.255.255.0
>          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>          RX packets:40 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:188 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:4077 (3.9 KiB)  TX bytes:17012 (16.6 KiB)

Note an IP address on eth0, most likely you have a default route using
eht0 as well. Check with 'ip route'.

> wlan0     Link encap:Ethernet  HWaddr 00:12:0E:98:67:FC
>          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>          RX packets:2 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:304 (304.0 B)  TX bytes:3932 (3.8 KiB)
>
> wmaster0  Link encap:UNSPEC  HWaddr 00-12-0E-98-67-FC-00-00-00-00-00-00-00-00-00-00
>          UP RUNNING  MTU:0  Metric:1
>          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
>
> Neither dhcp nor setting static IP for wlan0 - no ping.

Do you have Network Manager on? Please read:

http://wireless.kernel.org/en/users/Documentation/Reporting_bugs

Specifically the section that describes getting 'iw event -t' log and
Network Manager.

  Luis