Return-path: Received: from devils.ext.ti.com ([198.47.26.153]:58118 "EHLO devils.ext.ti.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751961Ab0JMOGs (ORCPT ); Wed, 13 Oct 2010 10:06:48 -0400 From: Shahar Levi To: Cc: Luciano Coelho Subject: [PATCH v4 01/03] wl1271: 11n Support, Add Definitions Date: Wed, 13 Oct 2010 16:09:39 +0200 Message-Id: <1286978981-21467-2-git-send-email-shahar_levi@ti.com> In-Reply-To: <1286978981-21467-1-git-send-email-shahar_levi@ti.com> References: <1286978981-21467-1-git-send-email-shahar_levi@ti.com> Sender: linux-wireless-owner@vger.kernel.org List-ID: Two acx commands: ht_capabilities & ht_information, 11n sta capabilities macro. Signed-off-by: Shahar Levi --- drivers/net/wireless/wl12xx/wl1271.h | 11 ++++- drivers/net/wireless/wl12xx/wl1271_acx.h | 81 +++++++++++++++++++++++++++++ drivers/net/wireless/wl12xx/wl1271_main.c | 15 +++++ 3 files changed, 106 insertions(+), 1 deletions(-) diff --git a/drivers/net/wireless/wl12xx/wl1271.h b/drivers/net/wireless/wl12xx/wl1271.h index 8a4cd76..45a2583 100644 --- a/drivers/net/wireless/wl12xx/wl1271.h +++ b/drivers/net/wireless/wl12xx/wl1271.h @@ -432,7 +432,12 @@ struct wl1271 { /* Our association ID */ u16 aid; - /* currently configured rate set */ + /* + * currently configured rate set: + * bits 0-15 - 802.11abg rates + * bits 16-23 - 802.11n MCS index mask + * support only 1 stream, thus only 8 bits for the MCS rates (0-7). + */ u32 sta_rate_set; u32 basic_rate_set; u32 basic_rate; @@ -509,4 +514,8 @@ int wl1271_plt_stop(struct wl1271 *wl); #define WL1271_PRE_POWER_ON_SLEEP 20 /* in miliseconds */ #define WL1271_POWER_ON_SLEEP 200 /* in miliseconds */ +/* Macros to handle wl1271.sta_rate_set */ +#define HW_BG_RATES_MASK 0xffff +#define HW_HT_RATES_OFFSET 16 + #endif diff --git a/drivers/net/wireless/wl12xx/wl1271_acx.h b/drivers/net/wireless/wl12xx/wl1271_acx.h index ebb341d..72597a2 100644 --- a/drivers/net/wireless/wl12xx/wl1271_acx.h +++ b/drivers/net/wireless/wl12xx/wl1271_acx.h @@ -964,6 +964,87 @@ struct wl1271_acx_rssi_snr_avg_weights { u8 snr_data; }; +/* + * ACX_PEER_HT_CAP + * Configure HT capabilities - declare the capabilities of the peer + * we are connected to. + */ +struct wl1271_acx_ht_capabilities { + struct acx_header header; + + /* + * bit 0 - Allow HT Operation + * bit 1 - Allow Greenfield format in TX + * bit 2 - Allow Short GI in TX + * bit 3 - Allow L-SIG TXOP Protection in TX + * bit 4 - Allow HT Control fields in TX. + * Note, driver will still leave space for HT control in packets + * regardless of the value of this field. FW will be responsible + * to drop the HT field from any frame when this Bit set to 0. + * bit 5 - Allow RD initiation in TXOP. FW is allowed to initate RD. + * Exact policy setting for this feature is TBD. + * Note, this bit can only be set to 1 if bit 3 is set to 1. + */ + __le32 ht_capabilites; + + /* + * Indicates to which peer these capabilities apply. + * For infrastructure use ff:ff:ff:ff:ff:ff that indicates relevance + * for all peers. + * Only valid for IBSS/DLS operation. + */ + u8 mac_address[ETH_ALEN]; + + /* + * This the maximum A-MPDU length supported by the AP. The FW may not + * exceed this length when sending A-MPDUs + */ + u8 ampdu_max_length; + + /* This is the minimal spacing required when sending A-MPDUs to the AP*/ + u8 ampdu_min_spacing; +} __packed; + +/* HT Capabilites Fw Bit Mask Mapping */ +#define WL1271_ACX_FW_CAP_HT_OPERATION BIT(0) +#define WL1271_ACX_FW_CAP_GREENFIELD_FRAME_FORMAT BIT(1) +#define WL1271_ACX_FW_CAP_SHORT_GI_FOR_20MHZ_PACKETS BIT(2) +#define WL1271_ACX_FW_CAP_LSIG_TXOP_PROTECTION BIT(3) +#define WL1271_ACX_FW_CAP_HT_CONTROL_FIELDS BIT(4) +#define WL1271_ACX_FW_CAP_RD_INITIATION BIT(5) + + +/* + * ACX_HT_BSS_OPERATION + * Configure HT capabilities - AP rules for behavior in the BSS. + */ +struct wl1271_acx_ht_information { + struct acx_header header; + + /* Values: 0 - RIFS not allowed, 1 - RIFS allowed */ + u8 rifs_mode; + + /* Values: 0 - 3 like in spec */ + u8 ht_protection; + + /* Values: 0 - GF protection not required, 1 - GF protection required */ + u8 gf_protection; + + /*Values: 0 - TX Burst limit not required, 1 - TX Burst Limit required*/ + u8 ht_tx_burst_limit; + + /* + * Values: 0 - Dual CTS protection not required, + * 1 - Dual CTS Protection required + * Note: When this value is set to 1 FW will protect all TXOP with RTS + * frame and will not use CTS-to-self regardless of the value of the + * ACX_CTS_PROTECTION information element + */ + u8 dual_cts_protection; + + u8 padding[3]; +} __packed; + struct wl1271_acx_fw_tsf_information { struct acx_header header; diff --git a/drivers/net/wireless/wl12xx/wl1271_main.c b/drivers/net/wireless/wl12xx/wl1271_main.c index 48a4b99..a585815 100644 --- a/drivers/net/wireless/wl12xx/wl1271_main.c +++ b/drivers/net/wireless/wl12xx/wl1271_main.c @@ -2134,6 +2134,21 @@ static const u8 wl1271_rate_to_idx_2ghz[] = { 0 /* CONF_HW_RXTX_RATE_1 */ }; +/* 11n STA capabilities */ +#define HW_RX_HIGHEST_RATE 72 + +#define WL1271_HT_CAP { \ + .cap = IEEE80211_HT_CAP_GRN_FLD | IEEE80211_HT_CAP_SGI_20, \ + .ht_supported = true, \ + .ampdu_factor = IEEE80211_HT_MAX_AMPDU_8K, \ + .ampdu_density = IEEE80211_HT_MPDU_DENSITY_8, \ + .mcs = { \ + .rx_mask = { 0xff, 0, 0, 0, 0, 0, 0, 0, 0, 0, }, \ + .rx_highest = cpu_to_le16(HW_RX_HIGHEST_RATE), \ + .tx_params = IEEE80211_HT_MCS_TX_DEFINED, \ + }, \ +} + /* can't be const, mac80211 writes to this */ static struct ieee80211_supported_band wl1271_band_2ghz = { .channels = wl1271_channels, -- 1.6.0.4