Message-ID: <53FDACD1.8090805@msgid.tls.msk.ru> (sfid-20140827_120315_366753_5BADCB14)
Date: Wed, 27 Aug 2014 14:02:57 +0400
From: Michael Tokarev <mjt@tls.msk.ru>
MIME-Version: 1.0
To: Arend van Spriel <arend@broadcom.com>
CC: brcm80211-dev-list@broadcom.com, linux-wireless@vger.kernel.org,
	netdev@vger.kernel.org
Subject: Re: BCM4313 & brcmsmac & 3.12: only semi-working?
References: <52BDE9DC.5040206@msgid.tls.msk.ru> <52BE9CF9.7030305@broadcom.com> <52BEC2F6.7010505@msgid.tls.msk.ru> <52D4FC8B.6090301@msgid.tls.msk.ru> <52F925A9.1030707@msgid.tls.msk.ru> <53526124.6050407@msgid.tls.msk.ru> <53FC1789.6020407@msgid.tls.msk.ru> <53FCA001.6090404@broadcom.com> <53FCB2A3.1050605@msgid.tls.msk.ru> <53FCFE1A.3060508@broadcom.com>
In-Reply-To: <53FCFE1A.3060508@broadcom.com>
Content-Type: text/plain; charset=UTF-8
Sender: linux-wireless-owner@vger.kernel.org

27.08.2014 01:37, Arend van Spriel wrote:
> On 08/26/14 18:15, Michael Tokarev wrote:
[]
> Well, sorry about that. I did see the other messages fly by and noticed you were using the wl driver so assumed you were fine with that.

That's past already.  I had several issues with wl driver,
and current issue is that even the latest (Aug-2014) version
of wl driver doesn't work with current kernel.  So I can't
really even compare wl and brcmsmac, -- in kernels < 3.16
brcmsmac does not work, but wl can't be compiled for 3.16,
and using different kernels for comparison is a bit wrong
because there may be differences in other areas.

>    Admittedly the brcmsmac got very little attention as all our resources were put on brcmfmac.

That happens. :)

[]
> Ok. Let's put frustration aside and make an effort. So could you make a trace using trace-cmd utility. The log can get quite big. The brcmsmac driver needs to be built with CONFIG_BRCM_TRACING enabled. Please execute the following commands (assuming you use ubuntu with network-manager):
> 
> $ sudo stop network-manager
> $ sudo insmod brcmfmac.ko
> $ sudo trace-cmd record -e brcmsmac:*
> 
> In another terminal:
> 
> $ sudo start network-manager
> 
> The trace-cmd must be stopped using ctrl-c.

Okay.  This turned out to be not so simple.

My initial attempt indicated that brcmsmac in 3.16 does
not work at all.  This isn't actually true - subsequent
attempts shows that it works.  I was ready to conclude
the problem is fixed (after transferring several gigs
of data over wifi, with tracing enabled or disabled,
after fresh boot or after reboot from wl-enabled kernel,
etc - it all worked.

Until I hit the same stall as I described initially, the
same which happened numerous times with kernel 3.12 ($subj).

After several mins of transferring it stalled.  But this
time (unlike with 3.12), it continued after about 30 secs.

So, while my initial test of 3.16 indicated the prob is still
here, at the same (or even worse) state, I can't really
reproduce it, at least in a reliable way.  There's something
wrong still, but at least current version is significantly
more useful than before (in a hope it wont stall at the
very wrong moment exactly ;).

There's one more difference between brcmsmac and wl -- with
wl, I see significantly better speed, -- it is about 5MB/sec,
while with brcmsmac it jumps between 2.0..4.5MB/sec (with
58..65Mbps connection rate in both cases).  Here's a typical
iwconfig output for brcmsmac version:

wlan0     IEEE 802.11bgn  ESSID:"mjt"
          Mode:Managed  Frequency:2.412 GHz  Access Point: 64:70:02:29:D9:30
          Bit Rate=65 Mb/s   Tx-Power=19 dBm
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=58/70  Signal level=-61 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:56355  Invalid misc:472   Missed beacon:0

I'll keep trying/testing various cases, in attempt to
understand what's going on.  For now, I can't provide the
requested traces (it wont be very useful, I guess).

BTW, are there other things not implemented in brcmsmac?
I see the module reminds about power management, what
does it mean?  Anything else missing?

Thank you!

/mjt