Return-path: Received: from glaubenleben.de ([85.214.105.140]:44443 "EHLO glaubenleben.de" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1758128AbcATHg6 (ORCPT ); Wed, 20 Jan 2016 02:36:58 -0500 From: Andreas Kemnade To: libertas-dev@lists.infradead.org, linux-wireless@vger.kernel.org, linux-kernel@vger.kernel.org, hns@goldelico.com Cc: Andreas Kemnade Subject: [PATCH v2 6/6] wireless:libertas: add an cfg80211 interface for powersaving Date: Wed, 20 Jan 2016 08:35:39 +0100 Message-Id: <1453275339-25122-7-git-send-email-andreas@kemnade.info> (sfid-20160120_083915_863467_F142D100) In-Reply-To: <1453275339-25122-1-git-send-email-andreas@kemnade.info> References: <1453275339-25122-1-git-send-email-andreas@kemnade.info> Sender: linux-wireless-owner@vger.kernel.org List-ID: This patch adds an interface for handling commands like iwconfig wlanX power on/off. Such an interface formerly existed when the driver used wext. While performance with sdio in polling mode without using powersave mode is quite bad, powersaving mode is unusable, so do not enable it under such conditions. Signed-off-by: Andreas Kemnade --- changes in v2: reordered, was 3/6 drivers/net/wireless/libertas/cfg.c | 38 +++++++++++++++++++++++++++++++++++++ 1 file changed, 38 insertions(+) diff --git a/drivers/net/wireless/libertas/cfg.c b/drivers/net/wireless/libertas/cfg.c index 8317afd..fd18d03 100644 --- a/drivers/net/wireless/libertas/cfg.c +++ b/drivers/net/wireless/libertas/cfg.c @@ -2038,6 +2038,43 @@ static int lbs_leave_ibss(struct wiphy *wiphy, struct net_device *dev) +int lbs_set_power_mgmt(struct wiphy *wiphy, struct net_device *dev, + bool enabled, int timeout) +{ + struct lbs_private *priv = wiphy_priv(wiphy); + + if (!(priv->fwcapinfo & FW_CAPINFO_PS)) { + if (!enabled) + return 0; + else + return -EINVAL; + } + /* firmware does not work well with too long latency with power saving + * enabled, so do not enable it if there is only polling, no + * interrupts (like in some sdio hosts which can only + * poll for sdio irqs) + */ + if (priv->is_polling) { + if (!enabled) + return 0; + else + return -EINVAL; + } + if (!enabled) { + priv->psmode = LBS802_11POWERMODECAM; + if (priv->psstate != PS_STATE_FULL_POWER) + lbs_set_ps_mode(priv, + PS_MODE_ACTION_EXIT_PS, + true); + return 0; + } + if (priv->psmode != LBS802_11POWERMODECAM) + return 0; + priv->psmode = LBS802_11POWERMODEMAX_PSP; + if (priv->connect_status == LBS_CONNECTED) + lbs_set_ps_mode(priv, PS_MODE_ACTION_ENTER_PS, true); + return 0; +} /* * Initialization @@ -2056,6 +2093,7 @@ static struct cfg80211_ops lbs_cfg80211_ops = { .change_virtual_intf = lbs_change_intf, .join_ibss = lbs_join_ibss, .leave_ibss = lbs_leave_ibss, + .set_power_mgmt = lbs_set_power_mgmt, }; -- 2.1.4