Date: Mon, 18 Dec 2017 14:47:45 +0100
From: Mylene JOSSERAND <mylene.josserand@free-electrons.com>
To: Jes Sorensen <jes.sorensen@gmail.com>
Cc: kvalo@codeaurora.org, linux-wireless@vger.kernel.org,
        netdev@vger.kernel.org,
        Thomas Petazzoni <thomas.petazzoni@free-electrons.com>,
        Maxime Ripard <maxime.ripard@free-electrons.com>
Subject: Re: Wifi RTL8723bu driver test: failed to scan
Message-ID: <20171218144745.4f4c985b@dell-desktop.home> (sfid-20171218_144827_082908_F8E41E55)
In-Reply-To: <75669dd0-1f25-fc7e-4a4d-a5549aeeb2cf@gmail.com>
References: <20171122105116.57c3c000@dell-desktop.home>
        <75669dd0-1f25-fc7e-4a4d-a5549aeeb2cf@gmail.com>
MIME-Version: 1.0
Content-Type: text/plain; charset=UTF-8
Sender: linux-wireless-owner@vger.kernel.org

Hello Jes,

Le Tue, 28 Nov 2017 11:14:10 -0500,
Jes Sorensen <jes.sorensen@gmail.com> a écrit :

> On 11/22/2017 04:51 AM, Mylene JOSSERAND wrote:
> > Hello Jes Sorensen,
> > 
> > I am currently testing a LM811 Wifi/BT USB dongle [1] on a Sinlinx
> > SinA33 Allwinner SoC board [2]. I saw that I should use the realtek
> > driver RTL8723BU for this USB dongle.
> > 
> > Currently, I am only testing the Wifi and the mainline driver (kernel
> > 4.14-rc7) does not seem to work. At least, the scanning does not output
> > anything.
> > 
> > I tested the driver recommended by LM Technologies [3] and it works
> > fine (scan, connect and ping are ok). Before investigating on the
> > differences between these two drivers, do you have any idea about this
> > issue?
> > 
> > Here are the commands and output I got with mainline's driver:  
> 
> I have not looked at the driver these LM Technologies people are
> referring to, but I am guessing it's the vendor code.
> 
> 8723bu is a little dicey because it has BT in the chip and if you enable
> that the two drivers need to interact, which rtl8xxxu currently doesn't
> know about. Check your dmesg output to make sure you don't have some BT
> thing loaded hijacking the chip.

I finally tested it again without any BT stuff enabled and I am still
not having any output on scanning.

I added DEBUG support to have all dev_dbg outputs for rtl8xxxu (core
and 8723b). Here is the log of boot and different iw commands:

http://code.bulix.org/56345t-242970?raw

Do you have any idea/hint to give me?
I checked the firmware: I am using the last one from linux-firmware's
repository. Have you already tried this chip? With which firmware?

Thank you very much for any help.

Best regards,

-- 
Mylène Josserand, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com