Return-path: Received: from mail2.candelatech.com ([208.74.158.173]:51986 "EHLO mail2.candelatech.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751338AbeEKVmS (ORCPT ); Fri, 11 May 2018 17:42:18 -0400 From: greearb@candelatech.com To: ath10k@lists.infradead.org Cc: kvalo@qca.qualcomm.com, linux-wireless@vger.kernel.org, Ben Greear Subject: [PATCH 1/3] ath10k: Add ath10k-ct firmware feature flags and descriptions. Date: Fri, 11 May 2018 14:42:09 -0700 Message-Id: <1526074931-23885-1-git-send-email-greearb@candelatech.com> (sfid-20180511_234222_503697_65E61C72) Sender: linux-wireless-owner@vger.kernel.org List-ID: From: Ben Greear These feature flags are used by ath10k-ct firmware. Add these so we can use them in future patches and so there are no warings about feature flags on loading ath10k-ct firmware. Signed-off-by: Ben Greear --- drivers/net/wireless/ath/ath10k/core.c | 17 +++++++++ drivers/net/wireless/ath/ath10k/core.h | 67 ++++++++++++++++++++++++++++++++++ 2 files changed, 84 insertions(+) diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c index 4cf54a7..f2f8f61 100644 --- a/drivers/net/wireless/ath/ath10k/core.c +++ b/drivers/net/wireless/ath/ath10k/core.c @@ -552,6 +552,23 @@ static const char *const ath10k_core_fw_feature_str[] = { [ATH10K_FW_FEATURE_NO_PS] = "no-ps", [ATH10K_FW_FEATURE_MGMT_TX_BY_REF] = "mgmt-tx-by-reference", [ATH10K_FW_FEATURE_NON_BMI] = "non-bmi", + [ATH10K_FW_FEATURE_WMI_10X_CT] = "wmi-10.x-CT", + [ATH10K_FW_FEATURE_CT_RXSWCRYPT] = "rxswcrypt-CT", + [ATH10K_FW_FEATURE_HAS_TXSTATUS_NOACK] = "txstatus-noack", + [ATH10K_FW_FEATURE_CT_RATEMASK] = "ratemask-CT", + [ATH10K_FW_FEATURE_HAS_SAFE_BURST] = "safe-burst", + [ATH10K_FW_FEATURE_REGDUMP_CT] = "regdump-CT", + [ATH10K_FW_FEATURE_TXRATE_CT] = "txrate-CT", + [ATH10K_FW_FEATURE_FLUSH_ALL_CT] = "flush-all-CT", + [ATH10K_FW_FEATURE_PINGPONG_READ_CT] = "pingpong-CT", + [ATH10K_FW_FEATURE_SKIP_CH_RES_CT] = "ch-regs-CT", + [ATH10K_FW_FEATURE_NOP_CT] = "nop-CT", + [ATH10K_FW_FEATURE_HTT_MGT_CT] = "htt-mgt-CT", + [ATH10K_FW_FEATURE_SET_SPECIAL_CT] = "set-special-CT", + [ATH10K_FW_FEATURE_NO_BMISS_CT] = "no-bmiss-CT", + [ATH10K_FW_FEATURE_HAS_GET_TEMP_CT] = "get-temp-CT", + [ATH10K_FW_FEATURE_HAS_TX_RC_CT] = "tx-rc-CT", + [ATH10K_FW_FEATURE_CUST_STATS_CT] = "cust-stats-CT", }; static unsigned int ath10k_core_get_fw_feature_str(char *buf, diff --git a/drivers/net/wireless/ath/ath10k/core.h b/drivers/net/wireless/ath/ath10k/core.h index e4ac8f2..c1342c5 100644 --- a/drivers/net/wireless/ath/ath10k/core.h +++ b/drivers/net/wireless/ath/ath10k/core.h @@ -711,6 +711,73 @@ enum ath10k_fw_features { /* Firmware load is done externally, not by bmi */ ATH10K_FW_FEATURE_NON_BMI = 19, + /* tx-status has the noack bits (CT firmware version 14 and higher ) */ + ATH10K_FW_FEATURE_HAS_TXSTATUS_NOACK = 30, + + /* Firmware from Candela Technologies, enables more VIFs, etc */ + ATH10K_FW_FEATURE_WMI_10X_CT = 31, + + /* Firmware from Candela Technologies with rx-software-crypt. + * Required for multiple stations connected to same AP when using + * encryption (ie, commercial version of CT firmware) + */ + ATH10K_FW_FEATURE_CT_RXSWCRYPT = 32, + + /* Firmware supports extended wmi_common_peer_assoc_complete_cmd that + * contains an array of rate-disable masks. This allows the host to + * have better control over what rates the firmware will use. CT + * Firmware only (v15 and higher) + */ + ATH10K_FW_FEATURE_CT_RATEMASK = 33, + + /* Versions of firmware before approximately 10.2.4.72 would corrupt + * txop fields during burst. Since this is fixed now, add a flag to + * denote this. + */ + ATH10K_FW_FEATURE_HAS_SAFE_BURST = 34, + + /* Register-dump is supported. */ + ATH10K_FW_FEATURE_REGDUMP_CT = 35, + + /* TX-Rate is reported. */ + ATH10K_FW_FEATURE_TXRATE_CT = 36, + + /* Firmware can flush all peers. */ + ATH10K_FW_FEATURE_FLUSH_ALL_CT = 37, + + /* Firmware can read memory with ping-pong protocol. */ + ATH10K_FW_FEATURE_PINGPONG_READ_CT = 38, + + /* Firmware can skip channel reservation. */ + ATH10K_FW_FEATURE_SKIP_CH_RES_CT = 39, + + /* Firmware supports NOP keep-alive message. */ + ATH10K_FW_FEATURE_NOP_CT = 40, + + /* Firmware supports CT HTT MGT feature. */ + ATH10K_FW_FEATURE_HTT_MGT_CT = 41, + + /* Set-special cmd-id is supported. */ + ATH10K_FW_FEATURE_SET_SPECIAL_CT = 42, + + /* SW Beacon Miss is disabled in this kernel, so you have to + * let mac80211 manage the connection. + */ + ATH10K_FW_FEATURE_NO_BMISS_CT = 43, + + /* 10.1 firmware that supports getting temperature. Stock + * 10.1 cannot. + */ + ATH10K_FW_FEATURE_HAS_GET_TEMP_CT = 44, + + /* Can peer-id be over-ridden to provide rix + retries for raw pkts? + * CT only option. + */ + ATH10K_FW_FEATURE_HAS_TX_RC_CT = 45, + + /* Do we support requesting custom stats */ + ATH10K_FW_FEATURE_CUST_STATS_CT = 46, + /* keep last */ ATH10K_FW_FEATURE_COUNT, }; -- 2.4.11