Received-SPF: pass (google.com: domain of linux-wireless-owner@vger.kernel.org designates 23.128.96.18 as permitted sender) client-ip=23.128.96.18;
Sender: mkenna=codeaurora.org@mg.codeaurora.org
DMARC-Filter: OpenDMARC Filter v1.3.2 smtp.codeaurora.org E1CC2C433D3
From:   Maharaja Kennadyrajan <mkenna@codeaurora.org>
To:     000ath11k@lists.infradead.org, linux-wireless@vger.kernel.org
Cc:     Maharaja Kennadyrajan <mkenna@codeaurora.org>
Subject: [PATCH v3 3/3] ath11k: Add support for beacon tx mode
Date:   Tue,  8 Jun 2021 20:34:03 +0530
Message-Id: <1623164643-7803-4-git-send-email-mkenna@codeaurora.org>
In-Reply-To: <1623164643-7803-1-git-send-email-mkenna@codeaurora.org>
References: <1623164643-7803-1-git-send-email-mkenna@codeaurora.org>
Precedence: bulk

Add support to configure the beacon tx mode in
the driver.

Beacons can be sent out in burst(continuously in a single shot
one after another) or staggered (equally spread out over beacon
interval) mode.

Use the below configuration in the hostapd/wpa_supplicant
for AP/MESH mode to configure the beacon tx mode.

"beacon_tx_mode=N", where N = 1 for STAGGERED beacon mode
and N = 2 for BURST beacon mode.

Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.5.0.1-00480-QCAHKSWPL_SILICONZ-1

Signed-off-by: Maharaja Kennadyrajan <mkenna@codeaurora.org>
---
 drivers/net/wireless/ath/ath11k/mac.c | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c
index 9d0ff15..dfc8644 100644
--- a/drivers/net/wireless/ath/ath11k/mac.c
+++ b/drivers/net/wireless/ath/ath11k/mac.c
@@ -2130,7 +2130,10 @@ static void ath11k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
 
 	if (changed & BSS_CHANGED_BEACON) {
 		param_id = WMI_PDEV_PARAM_BEACON_TX_MODE;
-		param_value = WMI_BEACON_STAGGERED_MODE;
+		if (info->beacon_tx_mode == NL80211_BEACON_BURST_MODE)
+			param_value = WMI_BEACON_BURST_MODE;
+		else
+			param_value = WMI_BEACON_STAGGERED_MODE;
 		ret = ath11k_wmi_pdev_set_param(ar, param_id,
 						param_value, ar->pdev->pdev_id);
 		if (ret)
@@ -2138,8 +2141,9 @@ static void ath11k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
 				    arvif->vdev_id);
 		else
 			ath11k_dbg(ar->ab, ATH11K_DBG_MAC,
-				   "Set staggered beacon mode for VDEV: %d\n",
-				   arvif->vdev_id);
+				   "Set %s beacon mode for VDEV: %d mode: %d\n",
+				   param_value ? "burst" : "staggered",
+				   arvif->vdev_id, param_value);
 
 		ret = ath11k_mac_setup_bcn_tmpl(arvif);
 		if (ret)
-- 
2.7.4