From:   David Mosberger-Tang <davidm@egauge.net>
Subject: [PATCH v4 2/2] wilc1000: Document enable-gpios and reset-gpios
 properties
Date:   Tue, 14 Dec 2021 16:33:22 +0000 (UTC)
Message-Id: <20211214163315.3769677-3-davidm@egauge.net>
In-Reply-To: <20211214163315.3769677-1-davidm@egauge.net>
References: <20211214163315.3769677-1-davidm@egauge.net>
MIME-Version: 1.0
To:     Ajay Singh <ajay.kathat@microchip.com>
Cc:     Adham Abozaeid <adham.abozaeid@microchip.com>,
        Claudiu Beznea <claudiu.beznea@microchip.com>,
        "David S. Miller" <davem@davemloft.net>,
        devicetree@vger.kernel.org, Jakub Kicinski <kuba@kernel.org>,
        Kalle Valo <kvalo@codeaurora.org>,
        linux-kernel@vger.kernel.org, linux-wireless@vger.kernel.org,
        netdev@vger.kernel.org, Rob Herring <robh+dt@kernel.org>,
        David Mosberger-Tang <davidm@egauge.net>
Content-Transfer-Encoding: 7bit
Content-Type: text/plain; charset=us-ascii
Precedence: bulk

Add documentation for the ENABLE and RESET GPIOs that may be needed by
wilc1000-spi.

Signed-off-by: David Mosberger-Tang <davidm@egauge.net>
---
 .../net/wireless/microchip,wilc1000.yaml        | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/wireless/microchip,wilc1000.yaml b/Documentation/devicetree/bindings/net/wireless/microchip,wilc1000.yaml
index 6c35682377e6..790a774a19ee 100644
--- a/Documentation/devicetree/bindings/net/wireless/microchip,wilc1000.yaml
+++ b/Documentation/devicetree/bindings/net/wireless/microchip,wilc1000.yaml
@@ -32,6 +32,21 @@ properties:
   clock-names:
     const: rtc
 
+  enable-gpios:
+    maxItems: 1
+    description: Used by wilc1000-spi to determine the GPIO line
+      connected to the ENABLE line.  If specified, reset-gpios
+      must be specified as well as otherwise the driver cannot
+      ensure the timing required between asserting ENABLE
+      and deasserting RESET.  This should be declared as an
+      active-high signal.
+
+  reset-gpios:
+    maxItems: 1
+    description: Used by wilc1000-spi to determine the GPIO line
+      connected to the RESET line.  This should be declared as an
+      active-low signal.
+
 required:
   - compatible
   - interrupts
@@ -51,6 +66,8 @@ examples:
         interrupts = <27 0>;
         clocks = <&pck1>;
         clock-names = "rtc";
+        enable-gpios = <&pioA 5 GPIO_ACTIVE_HIGH>;
+        reset-gpios = <&pioA 6 GPIO_ACTIVE_LOW>;
       };
     };
 
-- 
2.25.1