On Fri, May 03, 2013 at 11:01:48PM +0800, Yeoh Chun-Yeow wrote:
> Hi, Bob
>
> If we have two mesh interfaces which MBSS sharing is turned on and one
> Ethernet interface in the same host, can we use the brctl to add the mesh
> interfaces and Ethernet interface together, like the following?
>
> brctl add br-lan mesh0
> brctl add br-lan mesh1
> brctl add br-lan eth0
So in the patch, the frames are already forwarded between the
mesh interfaces, so we've at least tested the case like this:
mesh0/mesh1 shared
brctl addif br-lan mesh1
brctl addif br-lan eth0
Then frames destined for mesh1/eth0 that arrive at mesh0 will be
forwarded to the other devices and vice-versa. I imagine some
frame duplication would happen if both mesh devices were in the
bridge, but I haven't tried.
--
Bob Copeland %% http://www.bobcopeland.com