From: Tony Lindgren <[email protected]>
[ Upstream commit 11ef6bc846dcdce838f0b00c5f6a562c57e5d43b ]
At least on wl12xx, reading the MAC after boot can fail with a warning
at drivers/net/wireless/ti/wlcore/sdio.c:78 wl12xx_sdio_raw_read.
The failed call comes from wl12xx_get_mac() that wlcore_nvs_cb() calls
After the error, no wireless interface is created. Reloading the wl12xx
module makes the interface work.
Turns out the wlan controller can be in a low-power ELP state after the
boot from the bootloader or kexec, and needs to be woken up first.
Let's wake the hardware and add a sleep after that similar to
wl12xx_pre_boot() is already doing.
Note that a similar issue could exist for wl18xx, but I have not seen it
so far. And a search for wl18xx_get_mac and wl12xx_sdio_raw_read did not
produce similar errors.
Cc: Carl Philipp Klemm <[email protected]>
Signed-off-by: Tony Lindgren <[email protected]>
Signed-off-by: Kalle Valo <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Sasha Levin <[email protected]>
drivers/net/wireless/ti/wl12xx/main.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/net/wireless/ti/wl12xx/main.c b/drivers/net/wireless/ti/wl12xx/main.c
index 9d7dbfe7fe0c..c6da0cfb4afb 100644
@@ -1503,6 +1503,13 @@ static int wl12xx_get_fuse_mac(struct wl1271 *wl)
u32 mac1, mac2;
+ /* Device may be in ELP from the bootloader or kexec */
+ ret = wlcore_write32(wl, WL12XX_WELP_ARM_COMMAND, WELP_ARM_COMMAND_VAL);
+ if (ret < 0)
+ goto out;
+ usleep_range(500000, 700000);
ret = wlcore_set_partition(wl, &wl->ptable[PART_DRPW]);
if (ret < 0)