Hello all,
My setup is Intel 440GX MB with intergrated EEPro100.
When using Linux 2.2.18 the following happen: after reboot, I got:
eepro100: cmd_wait for (0xffffff90) timedout with (0xffffff90)!
and NIC is dead.
After power cycle, first boot works fine and all following boots (without
power off) - see above. Very seldom (I've noticed this 2 times during
2 monthes) this happen during normal operation.
2.2.12 and 2.4.x runs without problem (but have other problems which
it unusable for me).
--
Best regards,
Andriy mailto:[email protected]
On Wed, Feb 14, 2001 at 10:19:20AM +0200, Andriy Korud wrote:
> Hello all,
> My setup is Intel 440GX MB with intergrated EEPro100.
> When using Linux 2.2.18 the following happen: after reboot, I got:
> eepro100: cmd_wait for (0xffffff90) timedout with (0xffffff90)!
I reported the same hassle a while back. A patch was suggested and am
using it now. It's in the thread titled 'eepro100 + 2.2.18 + laptop problems'.
> After power cycle, first boot works fine and all following boots (without
> power off) - see above. Very seldom (I've noticed this 2 times during
> 2 monthes) this happen during normal operation.
I jsut take the interface down and up and eventually it goes ok. It
doesn't happen all the time either.
--
CaT ([email protected]) *** Jenna has joined the channel.
<cat> speaking of mental giants..
<Jenna> me, a giant, bullshit
<Jenna> And i'm not mental
- An IRC session, 20/12/2000