Just attempted upgrade from 2.4.21 on a Via M10000 Mini-ITX system that
was working perfectly. 2.4.22 results in eth0 not working, and constant
"NETDEV WATCHDOG: eth0: transmit timed out. Resetting".
___________________________________
Rod Bacon - Technical Manager
JASCO Consulting - http://www.jasco.net.au
Email - [email protected]
Phone : 03 9432 6376 Fax : 03 9432 6378
I saw that same message in 2.6.0-t3. Sometimes immediately the netcard
would not ping
and sometimes it would fail after a while.
Do you see an "irq ? disabled" message, too? That would be typical.
Try turning apic off in bios-cmos-setup and letting linux turn it on. I
don't have to use drastic
pci=noacpi, I can just disable serial and parallel and USB and turn apic
off in bios and run
with no cd drives. Easier for me.
-Bob
Rod Bacon wrote:
>Just attempted upgrade from 2.4.21 on a Via M10000 Mini-ITX system that
>was working perfectly. 2.4.22 results in eth0 not working, and constant
>"NETDEV WATCHDOG: eth0: transmit timed out. Resetting".
>
>