This does not fix any bug - this is just a code simplification. As
np is not used after passing it to v4l2_fwnode_endpoint_parse() its
refcount can be decremented immediately and at one location.
Signed-off-by: Nicholas Mc Guire <[email protected]>
---
Issue found during code reading.
Patch was compile tested with: x86_64_defconfig, MEDIA_SUPPORT=y
MEDIA_CAMERA_SUPPORT=y, V4L_PLATFORM_DRIVERS=y, OF=y, COMPILE_TEST=y
CONFIG_VIDEO_STM32_DCMI=y
(There are a few sparse warnings - but unrelated to the lines changed)
Patch is against 4.17.0 (localversion-next is next-20180608)
drivers/media/platform/stm32/stm32-dcmi.c | 5 +----
1 file changed, 1 insertion(+), 4 deletions(-)
diff --git a/drivers/media/platform/stm32/stm32-dcmi.c b/drivers/media/platform/stm32/stm32-dcmi.c
index 2e1933d..0b61042 100644
--- a/drivers/media/platform/stm32/stm32-dcmi.c
+++ b/drivers/media/platform/stm32/stm32-dcmi.c
@@ -1696,23 +1696,20 @@ static int dcmi_probe(struct platform_device *pdev)
}
ret = v4l2_fwnode_endpoint_parse(of_fwnode_handle(np), &ep);
+ of_node_put(np);
if (ret) {
dev_err(&pdev->dev, "Could not parse the endpoint\n");
- of_node_put(np);
return -ENODEV;
}
if (ep.bus_type == V4L2_MBUS_CSI2) {
dev_err(&pdev->dev, "CSI bus not supported\n");
- of_node_put(np);
return -ENODEV;
}
dcmi->bus.flags = ep.bus.parallel.flags;
dcmi->bus.bus_width = ep.bus.parallel.bus_width;
dcmi->bus.data_shift = ep.bus.parallel.data_shift;
- of_node_put(np);
-
irq = platform_get_irq(pdev, 0);
if (irq <= 0) {
dev_err(&pdev->dev, "Could not get irq\n");
--
2.1.4