I'm having trouble with e1000 in -mm1. (works in 2.6.1) The device is detected
and shows up and can be configured, but nothing ever goes out on the wire.
Here is the device info:
07:01.1 Ethernet controller: Intel Corporation: Unknown device 1010 (rev 01)
Subsystem: Intel Corporation: Unknown device 1011
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 49
Memory at fe9e0000 (64-bit, non-prefetchable) [size=128K]
I/O ports at dc00 [size=64]
Capabilities: [dc] Power Management version 2
Capabilities: [e4] PCI-X non-bridge device.
Capabilities: [f0] Message Signalled Interrupts: 64bit+ Queue=0/0
Enable-
tcpdump shows no activity when I attempt to use the e1000 interface.
Eric Whiting <[email protected]> wrote:
>
>
> I'm having trouble with e1000 in -mm1. (works in 2.6.1) The device is detected
> and shows up and can be configured, but nothing ever goes out on the wire.
Hum, OK. We'd better Cc the maintainers.
> Here is the device info:
>
>
> 07:01.1 Ethernet controller: Intel Corporation: Unknown device 1010 (rev 01)
> Subsystem: Intel Corporation: Unknown device 1011
> Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 49
> Memory at fe9e0000 (64-bit, non-prefetchable) [size=128K]
> I/O ports at dc00 [size=64]
> Capabilities: [dc] Power Management version 2
> Capabilities: [e4] PCI-X non-bridge device.
> Capabilities: [f0] Message Signalled Interrupts: 64bit+ Queue=0/0
> Enable-
>
>
> tcpdump shows no activity when I attempt to use the e1000 interface.
Eric Whiting wrote:
> I'm having trouble with e1000 in -mm1. (works in 2.6.1) The device is detected
> and shows up and can be configured, but nothing ever goes out on the wire.
Should be fixed when akpm updates the e1000 patch to
http://www.kernel.org/pub/linux/kernel/people/jgarzik/patchkits/2.6/2.6.1-netdrvr-exp1.patch.bz2
http://www.kernel.org/pub/linux/kernel/people/jgarzik/patchkits/2.6/2.6.1-netdrvr-exp1.log