Hello!!!
I am sorry for the letter, but allow to address to you with my problem.
Has bought Promise SX-6000 Pro the controller and has established on him
Linux Redhat. All - is excellent!! Has updated a nucleus for 2.6.5 - I
can not pick up the controller in any way. Source codes of a nucleus
taking place on your site do not approach for 2.6 nucleus :(
Can you know the possible decision of my problem??
Yours faithfully and hope, Alexey.
P.S.1 firmware drivers for 2.4.x kernel download is
http://www.eventus.de/linux.html
P.S.2
In make menuconfig has disconnected support of all PDC Promise. Has
included all I2O devices in a nucleus.
ns linux # cat .config|grep I2O
# I2O device support
CONFIG_I2O=y
CONFIG_I2O_PCI=y
CONFIG_I2O_BLOCK=y
CONFIG_I2O_SCSI=y
CONFIG_I2O_PROC=y
dmesg send 0 i2o controllers
I2O Core - (C) Copyright 1999 Red Hat Software
I2O: Event thread created as pid 17
i2o: Checking for PCI I2O controllers...
I2O configuration manager v 0.04.
(C) Copyright 1999 Red Hat Software
I2O Block Storage OSM v0.9
(c) Copyright 1999-2001 Red Hat Software.
i2o_block: Checking for Boot device...
i2o_block: Checking for I2O Block devices...
i2o_scsi.c: Version 0.1.2
chain_pool: 0 bytes @ f7ae85a0
(512 byte buffers X 4 can_queue X 0 i2o controllers)
lspci:
02:02.1 Class ff00: Intel Corp. 80960RM [i960RM Microprocessor] (rev 02)
(prog-if 01)
Subsystem: Promise Technology, Inc. SuperTrak SX6000 I2O CPU
Flags: bus master, medium devsel, latency 32, IRQ 22
Memory at f6000000 (32-bit, prefetchable) [size=4M]
Expansion ROM at <unassigned> [disabled] [size=64K]