ieee1394 + sbp2 has been irking me for a while, and I finally am
getting around to posting about it.
Using a fresh 2.6.7 on my powerbook G4 I plugged in my external
firewire drive(in a conversion kit) and insmod'd the sbp2 module(this
produced an error message like 'Trap set' or something I didn't write
it down). The kernel spits out:
Jun 16 22:54:12 [kernel] ieee1394: got invalid ack 252 from node 65473
(tcode 4)
Jun 16 22:54:13 [kernel] ieee1394: Error parsing configrom for node
0-01:1023
Jun 16 22:54:14 [kernel] ieee1394: Error parsing configrom for node
0-00:1023
Jun 16 22:54:15 [kernel] ieee1394: Error parsing configrom for node
0-01:1023
Jun 16 22:54:15 [kernel] ieee1394: Node added: ID:BUS[0-00:1023]
GUID[0001a3080
000ee0b]
Jun 16 22:54:15 [kernel] ieee1394: Node changed: 0-00:1023 ->
0-01:1023
Jun 16 22:54:24 [kernel] sbp2: $Rev: 1219 $ Ben Collins
<[email protected]>
It doesn't init the scsi device /dev/sda nor does it let me remove the
module. When I attempt to remove the module it says the module is in
use. Finally I attempt to unplug the drive I had a hard system
hang(this is not suprising).
Any idea what's going on ? I could actually use it under 2.4, but 2.6
I haven't had any luck.
Dave