I'm hitting a message that looks similar to this: (I wrote it down..)
Yikes!! There is a loop in the free list
No active SCB for reconnecting target
Issuing BUS DEVICE RESET
SAVED_TCL=0x0, ARG_1=0x3, SEQADR=0x11d
There is more, but this server needs to be running.
These are the scsi devices attached:
(scsi0) <Adaptec AIC-7890/1 Ultra2 SCSI host adapter> found at PCI 0/6/0
(scsi0) Wide Channel, SCSI ID=7, 32/255 SCBs
(scsi0) Downloading sequencer code... 392 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.31/3.2.4
<Adaptec AIC-7890/1 Ultra2 SCSI host adapter>
scsi : 1 host.
(scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 16.
Vendor: AccuRAID Model: AR-8600 Rev:
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:0:2:0) Synchronous at 20.0 Mbyte/sec, offset 8.
Vendor: OnStream Model: ADR50 Drive Rev: 2.20
Type: Sequential-Access ANSI SCSI revision: 02
Detected scsi tape st0 at scsi0, channel 0, id 2, lun 0
scsi : detected 2 SCSI generics 1 SCSI tape 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 180076544 [87928 MB]
I can reliably hit this whenever I copy 200-600mb of data from a windows
machine to this box over samba. We've tried changing the ram in the RAID
array, but that has had no effect.
Any help would be appreciated. Thanks.
: Michael J. Dikkema
| Systems / Network Admin - Internet Solutions, Inc.
| http://www.moot.mb.ca Work: (204) 982-1060
; [email protected]